Meade TE923W-M User Manual - Page 32

Remote Sensor Status The wave icon above the current channel display shows the connection status of the corresponding remote sensor: Icon Status Searching for the signals from the remote sensor Corresponding remote sensor signal received successfully No signals received for over 15 minutes All Remote Sensor Signals Search Activation The main unit can be manually activated to search for the signals from all remote sensors. Press and hold the DOWN button to enable the search. Rain Mode The main unit records the total amount of the rainfall for the last hour, 24 hours, past day, past week and the past month. The rainfall can be displayed in mm or inches. There is a daily rainfall alert that can be programmed in the unit if the daily rainfall exceeds a pre-programmed limit. Accessing Rain Mode Press main unit UP or DOWN until the RAIN icon on the display starts flashing. From the remote control: Press . Viewing Rain Statistics In the Rain Mode, press either SET or MEMORY button to recall a rain statistics for the past hour, past 24 hours, yesterday, past week or past month. Tip: For the rain rate, estimate the Last Hour rainfall value is understood as "inch/hr" or "mm/hr". Resetting the Rainfall Statistics Memory In the Rain Mode, press and hold the MEMORY button to reset all rainfall statistics. Setting Units for the Rain Display in inches or mm In the Rain Mode, press and hold the SET button to toggle rainfall data units between mm and inches. Enabling or Disabling the Daily Rainfall Alert • In the Rain Mode press the ALARM/CHART button to display either the current rainfall statistics or the daily rainfall alert with "ALARM HI" displayed. • If the alert is disabled, the "OFF" will be displayed; otherwise the rainfall alert value will be shown. • When the rainfall alert is displayed, press the UP or DOWN to enable or disable it. 32 TE923W IM1(ENG) HONEYWELL R.pmd 32 4/11/08, 5:28 PM