NEC 50XP10 User Manual - Page 11

Installation - continued Using the Remote: Install the remote control batteries. The remote control is powered by AA batteries. To install or replace batteries: Operating Range for the Remote Control Point the top of the remote control toward the monitor's remote sensor while pressing buttons. The remote control can be used from the front of the monitor at a maximum distance of 7 m/23 ft. from the front of the Plasma monitor's remote control sensor. The maximum horizontal and vertical angle for use of the remote is 30 degree within a distance of 3.5 m/11.5 ft. English CAUTION A. Press and slide to open the cover. B. Align the batteries according to the (+) and (-) indications inside the case. C. Replace the cover. CAUTION: Incorrect usage of batteries can result in leaks or bursting. NEC recommends the following battery use: • Place "AA" size batteries matching the (+) and (-) signs on each battery to the (+) and (-) signs of the battery compartment. • Do not mix battery brands. • Do not combine new and old batteries, or mix brands. This can shorten battery life or cause liquid leakage of batteries. • Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment. • Do not touch exposed battery acid, it may injure skin. • Do not drop or mishandle the remote. • Do not get the remote control wet. If the remote does get wet, wipe dry immediately. • Avoid excessive heat and humidity. • Do not dispose of batteries in fire. • Please follow government regulations or public environmental rules that apply in your country/area when disposing of used batteries. • When replacing, use only conventional nonrechargeable alkaline or manganese batteries. • There is a risk of explosion if batteries are replaced incorrectly. The remote control may not function when direct sunlight or strong illumination strikes the remote control sensor of the Plasma monitor, or when there is an object in the path of the sensor. Handling the Remote Control Do not open the remote control other than to install batteries. Do not allow water or other liquid to splash onto the remote control. If the remote control gets wet, wipe it dry immediately. Avoid exposure to heat and steam. NOTE: If you do not intend to use the Remote Control for a long period of time, remove the batteries. EXIT INPUT MUTE 30 POWER ON STANDBY RGB PICTURE MODE DVD/HD VIDEO PICTURE MEMORY SIZE 30 1 4 7 2 5 8 0 3 6 9 DISPLAY MENU SET AUTO SET UP + EXIT ZOOM VOL + POINTER + MUTE SPLIT SCREEN PIP S BY S SINGLE SWAP SELECT/FREEZE CAPTURE REMOTE ID SET RESET SLEEP REMOTE CONTROLLER RU-M113 English-8