NEC OP-720-69001 User Guide - Page 15
Windows NT 4.0 Installation
![]() |
UPC - 050927165788
View all NEC OP-720-69001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
CHAPTER 3 Windows NT 4.0 Installation Follow the procedure below to install the RealPort Ethernet 10/ 100+Modem 56 under Windows NT 4.0. For additional information, see the file HELPDOCS.HLP on the Windows 95/98/NT Installation Disk. For unattended install instructions, see www.xircom.com. PCMCIA Services Verification 1 Select Devices from the Control Panel. 2 Scroll down the Device list to the PCMCIA device. The Status should be Started and the Startup should be Boot. If this is not how PCMCIA is configured, then click Startup and set the Startup Type to Boot and click OK. Network Driver Installation 3 Shut off power to the computer (power down). 4 Insert the Xircom RealPort Ethernet 10/100+Modem 56 into the PC Card slot in the computer. 5 Power up the computer. 6 Select Network from the Control Panel. 7 Select the Adapters tab and click Add. 8 On the Select Network Adapters screen, click Have Disk. Insert the Xircom Windows 95/98/NT Installation Disk and verify that the specified path (for example: A:\) is correct. Click OK. 9 Select Xircom Ethernet 10/100 + Modem 56 and click OK. 10 At the Xircom Ethernet 10/100 + Modem 56 Setup screen, choose appropriate settings. Click OK. 11 At the Network screen click Close. 12 At the Network Settings Change screen, remove the Xircom diskette from the disk drive and click Yes. Do not remove the RealPort Ethernet 10/100+Modem 56 from the PC Card slot. The computer will shut down and restart.
![](/manual_guide/products/nec-op72069001-user-guide-c9c4578/15.png)