Netgear GS748TNA GS748Tv3 User Manual - Page 46

Enabling Jumbo Frames, Delete, Apply, Jumbo, Enable

Get Netgear GS748TNA PDF manuals and user guides View all Netgear GS748TNA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

Smart Switch Software User Manual GS748T Figure 4-18 To remove a multicast group: 1. In the line of the table that specifies the group, check the Delete box. 2. Click Apply to remove the group. Enabling Jumbo Frames Jumbo Frames are not an approved standard Ethernet frame size, so you must ensure that all of your networking equipment can support these nonstandard jumbo frames to prevent them from being dropped. The Jumbo Frame screen allows you to enable or disable jumbo frame support. The maximum default frame size is 1,518 bytes. When jumbo frame support is enabled, the frame size can vary from 64 bytes to 9,216 bytes. Jumbo frames is disabled by default. To configure a jumbo frame: 1. Select Switching > Switch Configuration from the main menu. The Jumbo Frame Configuration will display. 2. In the Jumbo Frame radio box, select Enable. 3. Click Apply. 4-16 v1.0, October 2007 Configuring the Switch

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
Smart Switch Software User Manual GS748T
4-16
Configuring the Switch
v1.0, October 2007
To remove a multicast group:
1.
In the line of the table that specifies the group, check the
Delete
box.
2.
Click
Apply
to remove the group.
Enabling Jumbo Frames
Jumbo Frames are not an approved standard Ethernet frame size, so you must ensure that all of
your networking equipment can support these nonstandard jumbo frames to prevent them from
being dropped. The Jumbo Frame screen allows you to enable or disable jumbo frame support. The
maximum default frame size is 1,518 bytes. When jumbo frame support is enabled, the frame size
can vary from 64 bytes to 9,216 bytes. Jumbo frames is disabled by default.
To configure a jumbo frame:
1.
Select Switching > Switch Configuration from the main menu. The Jumbo Frame
Configuration will display.
2.
In the
Jumbo
Frame radio box, select
Enable
.
3.
Click
Apply.
Figure 4-18