Netgear GSM4248P User Manual - Page 297

AV Line of Fully Managed Switches M4250 Series Main User Manual requests from partner devices. The paused port does not forward packets for the time that is specified in the pause frame. When the pause frame time elapses, or the utilization returns to a specified low threshold, the switch enables the port to again transmit frames. The switch also honors incoming pause frames by temporarily halting transmission. • Asymmetric: If the port buffers become full, the switch does not send pause frames, and data loss could occur. However, the switch does honor incoming pause frames by temporarily halting transmission. 18. In the Load Interval field, specify the load interval period for the port or LAG. This is the period for which data is used to compute load statistics. Enter the period in multiples of 30 seconds from 30 to 600. The default is 300 seconds. The smaller the load interval is, the more accurate the instantaneous rate for load statistics is. 19. Click the Apply button. Your settings are saved. 20. To save the settings to the running configuration, click the Save icon. The following table describes the nonconfigurable fields on the page. Table 77. Port configuration information Field Media Type Port Type Description The media type that the port supports. For normal ports this field is Normal. Otherwise the possible values are as follows: • Mirrored: The port is a mirrored port on which all the traffic is copied to the probe port. • Probe: Use this port to monitor a mirrored port. • Trunk Member: The port is a member of a link aggregation trunk. Look at the LAG pages for more information. Physical Status Link Status ifIndex The port speed and duplex mode. Indicates whether the port or LAG link is up or down. The ifIndex of the interface table entry associated with the port or LAG. Add port, LAG, and VLAN descriptions You can add a description for a port, LAG, and VLAN. Configure Switching Information 297 Main User Manual