Netgear GSM7212F GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 127

ProSafe Managed Switch port-channel static This command enables the static mode on a port-channel (LAG) interface. By default the static mode for a new port-channel is disabled, which means the port-channel is dynamic. However if the maximum number of allowable dynamic port-channels are already present in the system, the static mode for a new port-channel enabled, which means the port-channel is static.You can only use this command on port-channel interfaces. Default Format Mode disabled port-channel static Interface Config no port-channel static This command sets the static mode on a particular port-channel (LAG) interface to the default value. This command will be executed only for interfaces of type port-channel (LAG). Format Mode no port-channel static Interface Config port lacpmode This command enables Link Aggregation Control Protocol (LACP) on a port. Default Format Mode enabled port lacpmode Interface Config no port lacpmode This command disables Link Aggregation Control Protocol (LACP) on a port. Format Mode no port lacpmode Interface Config port lacpmode enable all This command enables Link Aggregation Control Protocol (LACP) on all ports. Format Mode port lacpmode enable all Global Config Switching Commands 127