Netgear GSM7212F GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 248

ProSafe Managed Switch Term Definition Metric The cost associated with this route. via Next-Hop The outgoing router IP address to use when forwarding traffic to the next router (if any) in the path toward the destination. Route-Timestamp The last updated time for dynamic routes. The format of Route-Timestamp will be • Days:Hours:Minutes if days > = 1 • Hours:Minutes:Seconds if days < 1 Interface The outgoing router interface to use when forwarding traffic to the next destination. For reject routes, the next hop interface would be Null0 interface. To administratively control the traffic destined to a particular network and prevent it from being forwarded through the router, you can configure a static reject route on the router. Such traffic would be discarded and the ICMP destination unreachable message is sent back to the source. This is typically used for preventing routing loops. The reject route added in the RTO is of the type OSPF Inter-Area. Reject routes (routes of REJECT type installed by any protocol) are not redistributed by OSPF/RIP. Reject routes are supported in both OSPFv2 and OSPFv3. The following shows example CLI display output for the command. (Switch) #show ip route Route Codes: R - RIP Derived, O - OSPF Derived, C - Connected, S - Static B - BGP Derived, IA - OSPF Inter Area E1 - OSPF External Type 1, E2 - OSPF External Type 2 N1 - OSPF NSSA External Type 1, N2 - OSPF NSSA External Type 2 C 1.1.1.0/24 [0/1] directly connected, 0/11 C 2.2.2.0/24 [0/1] directly connected, 0/1 C 5.5.5.0/24 [0/1] directly connected, 0/5 S 7.0.0.0/8 [1/0] directly connected, Null0 OIA 10.10.10.0/24 [110/6] via 5.5.5.2, 00h:00m:01s, 0/5 C 11.11.11.0/24 [0/1] directly connected, 0/11 S 12.0.0.0/8 [5/0] directly connected, Null0 S 23.0.0.0/8 [3/0] directly connected, Null0 show ip route summary Use this command to display the routing table summary. Use the optional all parameter to show the number of all routes, including best and non-best routes. To include only the number of best routes, do not use the optional parameter. Format Modes show ip route summary [all] • Privileged EXEC • User EXEC Routing Commands 248