Netgear GSM7212F GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 43

ProSafe Managed Switch Term Physical Mode Physical Status Link Status Link Trap LACP Mode Definition The desired port speed and duplex mode. If auto-negotiation support is selected, then the duplex mode and speed is set from the auto-negotiation process. Note that the maximum capability of the port (full duplex -100M) is advertised. Otherwise, this object determines the port's duplex mode and transmission rate. The factory default is Auto. The port speed and duplex mode. The Link is up or down. This object determines whether or not to send a trap when link status changes. The factory default is enabled. LACP is enabled or disabled on this port. show port protocol This command displays the Protocol-Based VLAN information for either the entire system, or for the indicated group. Format Mode show port protocol { | all} Privileged EXEC Term Group Name Group ID Protocol(s) VLAN Interface(s) Definition The group name of an entry in the Protocol-based VLAN table. The group identifier of the protocol group. The type of protocol(s) for this group. The VLAN associated with this Protocol Group. Lists the unit/slot/port interface(s) that are associated with this Protocol Group. show port description This command displays the port description for every port. Format Mode show port description Privileged EXEC Term Interface Description Definition Valid slot and port number separated by forward slashes Shows the port description configured via the "description" command Switching Commands 43