Nikon 9622 D700 User's Manual - Page 178
Select preset d-0., Direct Measurement Mode, Auto meter-off delay, Preset d-0, Direct sunlight
View all Nikon 9622 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
If lighting is too dark or too bright, the camera may be unable to measure white balance. A flashing b a will appear in the control panel and viewfinder (at default settings, the displays will flash for about six seconds). Press the shutterrelease button halfway to return to Step 4 and measure white balance again. Control panel Viewfinder 6 Select preset d-0. If the new value for preset white balance will be used immediately, select preset d-0 by pressing the WB button and rotating the sub-command dial until d-0 is displayed in the control panel. r D Direct Measurement Mode If no operations are performed while the displays are flashing, direct measurement mode will end in the time selected for Custom Setting c2 (Auto meter-off delay, pg. 296). The default setting is six seconds. A Preset d-0 The new value for white balance will be stored in preset d-0, automatically replacing the previous value for this preset (no confirmation dialog will be displayed). A thumbnail will be displayed in the preset white balance list. To use the new value for white balance, select preset d-0 (if no value has been measured for white balance before d-0 is selected, white balance will be set to a color temperature of 5,200 K, the same as Direct sunlight). The new white balance value will remain in preset d-0 until white balance is measured again. By copying preset d-0 to one of the other presets before measuring a new value for white balance, up to five white balance values can be stored (pg. 153). 152