Nokia 100i Installation Guide - Page 45

Installing a Network Interface Card

Get Nokia 100i - IP VPN - Gateway PDF manuals and user guides View all Nokia 100i manuals
Add to My Manuals
Save this manual to your list of manuals

Page 45 highlights

Installing a Network Interface Card 7. Place the screws through the standoff holes on the card and into the standoffs on the motherboard. Screw Accelerator card Standoff hole Motherboard standoff 8. Turn each screw clockwise to attach the card to the standoffs. Do not tighten completely. 9. Make sure that all four standoff connections are properly aligned. 10. To secure the connections, tighten the screws firmly, but do not overtighten. 11. Slide the chassis assembly back into the gateway and resecure the two retaining screws. Reseating the chassis assembly automatically restores power to the gateway. The accelerator card is automatically detected and enabled by default. Installing a Network Interface Card All network interface cards (NICs) installed in the Nokia 100i gateway are installed in the 6U PMC carrier. Ethernet NICs can occupy any of the slots or subslots in a gateway that other I/O cards do not occupy. Nokia 100i Installation Guide 45

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
Installing a Network Interface Card
Nokia 100i Installation Guide
45
7.
Place the screws through the standoff holes on the card and into the
standoffs on the motherboard.
8.
Turn each screw clockwise to attach the card to the standoffs.
Do not tighten completely.
9.
Make sure that all four standoff connections are properly aligned.
10.
To secure the connections, tighten the screws firmly, but do not
overtighten.
11.
Slide the chassis assembly back into the gateway and resecure the two
retaining screws.
Reseating the chassis assembly automatically restores power to the
gateway.
The accelerator card is automatically detected and enabled by default.
Installing a Network Interface Card
All network interface cards (NICs) installed in the Nokia 100i gateway are
installed in the 6U PMC carrier. Ethernet NICs can occupy any of the slots or
subslots in a gateway that other I/O cards do not occupy.
Screw
Accelerator card
Standoff hole
Motherboard standoff