Oki OKIPAGE10i Flash Simm Hardware Installation Guide - Page 5

InOstvaellrivnigewFlash Memory in the OKIPAGE® 10i, 10i/n, 10e, 10ex, 12i and 12i/n Printers For models listed above, the flash memory SIMM is installed on one of the following optional accessory boards. · 1 MB Memory Expansion Kit (Part # 70033101) · RS-232C Serial Interface Kit (Part # 00025302) · OKILAN® 310e Network Interface Kit (OKIPAGE 10i only) (Part # 70032901) · OKILAN® 310e+ Network Interface Kit (OKIPAGE 12i only) (Part # 70032902) If your printer is not equipped with one of these accessories, you will need to purchase the accessory to install the Flash SIMM in the printer. Expansion sockets are provided on each board included in the option kits. Preparing Your Printer ! CAUTION! SIMMs and circuit boards can be damaged by static electricity and rough handling. Keep the SIMM card and option board in the packaging until you're ready to perform the installation. To avoid damage to the SIMM card, ground yourself by touching the chassis of your computer each time before handling. ! WARNING! Disconnect printer from power before beginning installation procedure. 1 Turn the printer off and unplug the power cord. 2 Detach the interface cable. 3 If an option board is already installed in your printer, turn the screws counterclockwise, then slide the board out of the printer. | Hardware Installation Guide: English 5