Oki OkiPOS406 OkiPOS406 Users Guide - Page 108
Appendix D: Serial Interface, D-1. RS-232C Connector
View all Oki OkiPOS406 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Appendix D: Serial Interface D-1. RS-232C Connector Pin No. 25 Pin 9 Pin Signal name Direction 1 F-GND - 23 TXD OUT 32 RXD IN 47 RTS OUT 5 N/C 8 CTS IN 66 DSR IN 75 8~19 1,9 20 4 S-GND N/C DTR - OUT Function Frame ground Transmission data Receive data Same as DTR signal. Not used Status of this signal is not checked. • DIP Switch 3-7=OFF STAR Mode Status of this signal is not checked. ESC/POS Mode In DTR/DSR communication mode, indicates whether data receive from host is enabled or disabled. Space: Receive enabled Mark: Receive disabled (except when transmitting data by DLE EOT, and GS a) This signal is not checked in the X-ON/X-OFF communication mode. • DIP Switch 3-7=ON This signal used for external reset. Priter is reset whenever signal is in mark state with pulse width of 1mS or more. Signal ground Not used Indicates whether data receive from host is enabled or disabled. 1) DTR/DSR Communication Mode This signal indicates whether the printer is busy. SPACE indicates that the printer is ready to receive data, and MARK indicates that the printer is busy. The busy condition can be changed by using DIP SW 1-6 as follows: APPENDIX - 105 -