Oki PM4410 Guide: Setup, PM4410 (English) - Page 31

Left Tractor viewed from the back of the printer, Finish Up

Get Oki PM4410 PDF manuals and user guides View all Oki PM4410 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

Left Tractor (viewed from the back of the printer) 1. Open the tractor cover, place the paper holes over the pins and close the cover. 2. Fine tune the position of the right tractor to center the paper holes on the pins of both tractors, then push the right lock lever back. Finish Up 1. Make sure that the feed stack of paper is directly aligned (left-right) with its entry point into the tractors: this will promote a smooth flow of paper into the printer. 2. Close the rear-feed access cover and the back access door. 3. Press FF/LOAD to load the paper into the print path. The printer is set to a default rear-feed paper width of 13.6 inches (136 columns). If you are using 9-inch paper, you must enter the printer menu and change the setting to 8 inches (80 columns) to avoid printing on the platen and Pacemark 4410 Setup Guide E-29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
E-29
Pacemark 4410 Setup Guide
Left Tractor (viewed from the back of the printer)
1. Open the tractor cover, place the paper holes over the pins and close
the cover.
2. Fine tune the position of the right tractor to
center the paper holes on
the pins of both tractors
, then push the right lock lever back.
Finish Up
1. Make sure that the feed stack of paper is directly aligned (left-right)
with its entry point into the tractors: this will promote a smooth flow
of paper into the printer.
2. Close the rear-feed access cover and the back access door.
3. Press FF/LOAD to load the paper into the print path.
The printer is set to a default rear-feed paper width of 13.6
inches (136 columns). If you are using 9-inch paper, you
must enter the printer menu and change the setting to 8
inches (80 columns) to avoid printing on the platen and