Onkyo PR-SC5509 Owner Manual - Page 91
Component Video Monitor Out, Monitor Out S
View all Onkyo PR-SC5509 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
■ If the picture on your TV/monitor connected to the HDMI output(s) is unstable, try switching the DeepColor function off To turn off the DeepColor function, simultaneously press the CBL/SAT and ON/STANDBY buttons on the AV controller. While holding down CBL/SAT, press ON/STANDBY repeatedly until "Off" appears on the display and then release both buttons. To reactivate the DeepColor function, repeat the above process until "On" appears on the display and release the buttons. The AV controller contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in. Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit's malfunction. Before you record important data, make sure that the material will be recorded correctly. Before disconnecting the power cord from the wall outlet, set the AV controller to standby. Important Note Regarding Video Playback The AV controller can upconvert component video, SVideo, and composite video sources for display on a TV connected to the HDMI output(s). However, if the picture quality of the source is poor, upconversion may make the picture worse or disappear altogether. In this case, try the following: 1 If the video source is connected to a component video input, connect your TV to the COMPONENT VIDEO MONITOR OUT. If the video source is connected to an S-Video input, connect your TV to a MONITOR OUT S. If the video source is connected to a composite video input, connect your TV to the MONITOR OUT V. 2 On the main menu, select "Input/Output Assign" and then "Component Video Input" (➔ page 51). If the video source is connected to COMPONENT VIDEO IN 1, select the relevant input selector, and assign it to "IN1". If the video source is connected to COMPONENT VIDEO IN 2, select the relevant input selector, and assign it to "IN2". If the video source is connected to COMPONENT VIDEO IN 3, select the relevant input selector, and assign it to "IN3". If the video source is connected to an S-Video input or composite video input, select the relevant input selector, and assign it to Tip • To by-pass the upconversion, set the "Picture Mode" setting to "Direct" (➔ page 61). En 91