Onkyo TX-NR1007 Owner Manual - Page 48
Notes, Through, 480p 480p/576p, 1080i, Source, Use the Up and Down, tons to select Resolution,
View all Onkyo TX-NR1007 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
First Time Setup-Continued 5 Use the Up and Down [R]/[X] but- tons to select "Resolution", and use the Left and Right [F]/[S] buttons to select: Through: Select this to pass video through the AV receiver at the same resolution and with no conversion. Auto* : Select this to have the AV receiver automatically convert video at resolutions not supported by your TV. 480p (480p/576p): Select this for 480p or 576p output and video conversion as necessary. 720p: Select this for 720p output and video conversion as necessary. 1080i: Select this for 1080i output and video conversion as necessary. 1080p* : Select this for 1080p output and video conversion as necessary. Source: Output will be according to the resolution level which was set in the "Picture Adjust" setting (see page 100). Tips: • The "Resolution" setting can also be set using the [VIDEO] button on the remote controller. • The "Resolution" setting is set respectively of main, sub, and analog. Notes: • Settings marked with an asterisk (* ) are not available when the "Monitor Out" setting is set to "Analog". • If the "Monitor Out" setting is set to "Both", this setting is fixed at "Auto". 6 Press the [SETUP] button. The setup menu closes. • This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button. Notes: • See page 27 for charts showing how the "Monitor Out" and "Resolution" settings affect the video signal flow through the AV receiver. 48