Onkyo TX-NR1007 Owner Manual - Page 61
Changing the Speaker Settings Manually, Using Powered Subwoofers, Retry, Cancel, Notes - reviews
View all Onkyo TX-NR1007 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
First Time Setup-Continued MultEQ XT: Auto Setup Speaker Detect Error FL : Error SL : Yes FWL : --FHL : --SBL : Yes C : Yes FR : Yes SR : Yes FWR : --FHR : --SBR : Yes SW1 : Yes SW2 : Yes Retry Cancel The speaker type detected does not match what was expected. The speaker may be incorrect type or broken. Please check that it is the correct speaker type. ❏ Speaker Matching Error! MultEQ XT: Auto Setup Speaker Matching Error! Retry Cancel The number of speakers detected on the second measurement and later was different to the number detected on the first measurement. Make sure speakers that could not be detected are connected properly. Retry: Return to step 2 and try again. Cancel: Cancel the room correction and speaker setup. ❏ Writing Error! MultEQ XT: Auto Setup Writing Error! Changing the Speaker Settings Manually If you wish to make changes to the settings found during the room correction and speaker setup, follow the directions on pages 90 to 93. Notes: • Please note that THX recommends any THX main speakers be set to "80Hz(THX)". If you set up your speakers using Audyssey MultEQ XT Room Correction and Speaker Setup, please make sure manually that any THX speakers are set to 80 Hz (THX) crossover (see page 90). • Sometimes due to the electrical complexities of subwoofers and the interaction with the room, THX recommends setting the level and the distance of the subwoofer manually. • Sometimes due to interaction with the room, you may notice irregular results when setting the level and/or distance of the main speakers. If this happens, THX recommends setting them manually. Using Powered Subwoofers If you're using powered subwoofers that output very low-frequency sound at a low volume level, it may not be detected by Audyssey MultEQ® XT Room Correction and Speaker Setup. If the "Subwoofer" appears on the "Review SP Configuration" screen as "No", increase the subwoofer's volume to the half-way point, set it to its highest crossover frequency, and then try running Audyssey MultEQ XT Room Correction and Speaker Setup again. Note that if the volume is set too high and the sound distorts, detection issues may occur, so use an appropriate volume level. If the subwoofer has a lowpass filter switch, set it to Off or Direct. Refer to your subwoofer's instruction manual for details. Retry Cancel This message appears if saving fails. Try saving again. If this message appears after 2 or 3 attempts, the AV receiver is probably malfunctioning. Contact your Onkyo dealer. Retry: Return to step 2 and try again. Cancel: Cancel the room correction and speaker setup. 61