Onkyo TX SR606 Instruction Manual - Page 42
Speaker Settings - speaker sets
UPC - 751398008092
View all Onkyo TX SR606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
First Time Setup-Continued Speaker Settings 2 If you change these settings, you must run the automatic speaker setup again (see page 38). Use the Up and Down [ ]/[ ] buttons to select "2. Speaker Setup," and then press [ENTER]. ENTER SETUP RECEIVER 3 Use the Up and Down [ ]/[ ] buttons to select "1. Speaker Settings," and then press [ENTER]. If the impedance of any speaker is 4 ohms or more but less than 6, set the Speaker Impedance to 4 ohms. North American models do not support speakers with an impedance of less than 6 ohms. To use bi-amping, you must change the Speaker Type setting. For hookup information, see page 17. Notes: • When bi-amping is used, the AV receiver is able to drive up to 5.1 speakers in the main room. • Before you change these settings, turn down the vol- ume. 1 Press the [RECEIVER] button, followed by the [SETUP] button. The main menu appears onscreen. If the main menu doesn't appear, make sure the appropriate external input is selected on your TV. 4 Use the Up and Down [ ]/[ ] buttons to select "Speaker Impedance," and use the Left and Right [ ]/[ ] buttons to select: 4 ohms: Select if the impedance of any speaker is 4 ohms or more but less than 6. 6 ohms: Select if the impedances of all speakers are between 6 and 16 ohms. 5 Use the Up and Down [ ]/[ ] buttons to select "Speaker Type," and use the Left and Right [ ]/[ ] buttons to select: Normal: Select this if you've con- nected your front speakers normally. Bi-Amp:Select this if you've con- nected your front speakers for bi-amped operation. 6 Press the [SETUP] button. Setup closes. Note: • This procedure can also be performed on the AV receiver by using its [SETUP], [ENTER], and arrow buttons. 42