Onkyo TX-SV727 Owner Manual - Page 12

Making system connections IPM ON OFF IN) (VDP) VIDEO VIDEO IN OUT AUDIO OUT L R. IPM ON OFF (NI (VDP) TO MONITOR TV (VIDEO IN) VIDEO OUT AUDIO OUT L R Connecting a monitor (MONITOR OUT) I . Connect the TV VIDEO input to this unit MONITOR OUT jack. There is no need to perform an audio connection since sound will be sent directly from this unit to the speaker systems. 2. This unit does not have an RF converter. Therefore, it can be used with only a monitor TV equipped with a video input jack. 3. Interference may be caused between the TV and this unit. If this interference occurs, place this unit and the TV as far apart as possible. We do not recommend the use of a common TV/FM antenna (see antenna section). IPM (Intelligent Power Management System) If the TV connected to VIDEO-1 is turned on, this unit is automatically turned on and the input selector is set to VIDEO-1. The IPM system then automatically switches the unit off when the TV is switched off (provided that the input selector remains set to VIDEO- 1 ). A. Connection where IPM will operate Set the IPM switch to ON. VIDEO-1 TV is displayed on the display. B. Connection where IPM will not operate Set the IPM switch to OFF. VIDEO-1 VDP is displayed on the di spiny. NOTES: • This unit will automatically switch on approximately three to five seconds after the TV comes on. • The IPM function is not operating if the TV screen remains blank, even if the TV is swiched on. TX-SV727/R RI REMOTE CONTROL COMPACT DISC PLAYER RI REMOTE CONTROL O=I I O CASSETTE TAPE DECK RI REMOTE CONTROL O Green or Black Gray 65) (DI (Z) O Connections for remote control A cassette tape deck and compact disc player that have the ONKYO RI mark can be operated using the accessory remote control with this unit. Connect a remote control cable to the black jack with the RI mark. Never connect it to the green or gray jack with the 'TRY, mark. Connect the remote control cable as shown left side to enable remote control operation of other components. NOTES: • To enable proper remote control operation, both the RI cable and the audio cables must be connected between units. • This unit's remote control cannot be used to control ONKYO turntables. • An RI remote control cable equipped with a 1/8" (3.5 mm) miniature 2 conductor phone plug is included with this unit and with any other component with the RI mark. 12