Onkyo TX-SV727 Owner Manual - Page 18

Learning remote control codes using the 10 programmable buttons Universal Programmable Remote Control RC-288M This remote control is a remote control which uses high-level computer technology to provide programming functions. If you are using a product made by another company which has a remote control, you can memorize the -codes of that product into this remote control. If you are using an ONKYO compact disc player. or cassette tape deck that has the RI mark, there is no need to memorize the codes of its remote control into this remote control. All of your remote control needs can be satisfied using this remote control alone. NOTES: • Commands of systems with the RI ONKYO mark are already stored at the A and B-SUB ROOM positions of the A/B-SUB ROOM/LEARN Selector switch. There is no need to "learn" them. (The RI mark is ONKYO's own mark.) • If necessary, the 10 programmable buttons on the remote control can be reprogrammed to have a different function when the switch is in the A position, but not the B-SUB ROOM position. • The output of most infrared remote control transmission units on the market today consists of a series of pulses (codes). By changing these codes, functions can be differentiated between products from different manufacturers. In order to mimic other remote controls, and control different devices with different codes, this remote control must be assigned the same codes as the other remote controls. Display indicator SENDING LEARNED SLEEP a SUB POOM A , I 1-1 -EA. IED SPEAKERS MAIN REMOTE DIMMER DEO IDES-3 VIDEO-4 E -- 1 PE' 'APE-2 I I TUNER CD PHONO PROVA, AREA PS VIDEO L__1G I I -I I - POWER • VDP ► I I 4-4 VCR w.s. CD r I LNI-ER ESCAPE 1: -7i 1 1 A/B-SUB ROOM /LEARN selector switch PROGRAMABLE AREA Displays and switches The Display indicator (SENDING/LEARNED) This indicator acts as a guide when this unit "learned" and is "sending'. commands. It also warns the user when an error is made or when battery power is low. If the indicator flashes During learning, the indicator flashes if the codes being learnt are unstable and cannot be memorized properly. This is because this remote control requires highly stable transmission output for identifying codes. To ensure the reception of stable codes, place both remote control on a table or other level surface and position them at a fixed distance and orientation, facing each other. Another possible reason for unstable transmission codes is wornout batteries on the existing remote control. Replace the batteries of the existing remote control with new ones, then repeat the learning operation. If the indicator flashes when a button is pressed on this remote control, it means that this remote control batteries are worn out. Replace its batteries with new ones. This remote control can also store remote control codes of other functions that are not indicated by these symbols, but they will have to use these buttons. Be sure to assign functions to the buttons with the corresponding function names and/or symbols if at all possible. If functions and button names are different, the function which actually operates will be different from the label of the button you pushed. For instructions regarding the operation of "learned" units, please refer to the individual instruction manuals for each product. Even after codes have been memorized, please keep your existing remote control in a safe place. If the memorized codes are lost when the batteries run down, etc., it will be necessary to memorize them once again using the existing remote control. The programmable buttons The Programmable section consists of the following functions. For TV: Power (POWER) Channel up/down ( •-CH-• ) For VDP: Power (POWER ) For VCR: Play ( 10.), Stop ( •) Play ( ►), Stop (•) Rewind (44), Fast Forward (1.10.) 18