Onkyo TX-SV727 Owner Manual - Page 17

2. ONKYO MULT ROOM system (Models other than U. S. A. and Canadian models) When using only the HR-I0 (optional) to control this unit in the main room from another room, connect them as shown below. In this case, both the ONKYO CD player and the cassette tape deck bearing the RI mark and connected to this unit can be controlled. MAIN Loudspeaker set O TX-SV727/R Main room Rear panel of the TX-SV727/R ,RONT SPE.EHS + - VAIN CD REMOTE Loudspeaker set O HR-10 O 0 0 REMOTE Loud speaker set O MAIN Loud speaker set *.? Remote control Another room O Bottom of HR-10 OO Green terminal to REMOTE speakers To enable remote control operation when this unit is mounted in a rack which will not permit infrared beams to pass, mount the HR-10 somewhere outside the rack, so that the signals can be picked up. If all components bear the RI mark, connect a cable from the HR-10 to the 111RDK iput on this unit, and from there connect RI cables to the other components (see page 11). If the other components can receive infrared remote control signals, but do not have the RI mark, mount an HE50(AC) inside the cabinet so that signals from it will reach the sensors in all components, and connect it to the HR-10 with an cable. Remote control aunts snort HR-10 HE-50 (AC) EX-SV727 R CASSETTE TAPE DECK COMPACT DISC PLAYER connection example using the HR-10 (optional) and HE-50 (AC) (optional) to control components in the main room from another room is shown below. If all the components can not be controlled by the HE-50 (AC) alone because they are installed at various places in the main room, use a Remote Emitter head HE-10 (optional). This also allows you to control components that are not ONKYO, or do not have an RI mark, as long as they can be controlled by infrared remote control. When using an HE-50(AC), the HE-50(AC) or HE-10 should also face this unit. Note on multiple room cables Any remote sensors and emitters (HR-10, HE-50(AC), HE-I0) should be connected with low capacitance shielded 2-wire coaxial cables with 1/8" (3.5 mm diameter) mini-plug connectors. Maximum cable length is determined by the characteristics of the particular cables used but up to approximately 164' (50 m) lengths are generally practical. Refer to the instruction manual which comes with the HR-10 when making these connections. Sets of loudspeakers in another room should be connected to this unit in the main room with low impedance cables. MAIN Loud sperker set MAIN Loud sperker set REMOTE Loud sperker set AC adaptor to AC adaptor O O HE-10 L HE-50 (AC) TX-SV727/R Main room DLIT 9, o O 6 , oanrieo NESC Bottom of HE-50 (AC) / to HE-10 Rear panel of the TX-SV7271R A A.A REMOTE Loud sperker set 1 dreen terminal rn' il IN OUT o REMOTE speakers HR-10 0 O Remote control Another room O orrx-seO Bottom of HR-10 NOTES: • Always unplug the AC power cords for this unit and HE-50(AC) when connecting the irr-? • Insert the rrR mini-plug into the green terminal on the rear panel of this unit. 17