Onkyo TX-SV828THX Owner Manual - Page 18

Connection for Multiple-Room Remote Control U.S.A. and Canadian models (Xantech Multiple-Room systems) Do not plug in the power cord until all connections have been made. When making connections (f) through ('), be sure to connect the units as shown in the connection diagram below. Do not make a mistake when connecting the units. A. Operating components displaying Onkyo's RI mark from the sub-room Components mounted in a rack should be connected as shown below to enable remote control operation. MAIN ROOM 1. Onkyo components (a) Speaker (Main room) TX-SV828THX Speaker (Main room) 4. Connectingj- Remote block < control _ SUB ROOM 5. Dinky Link or J-Box Receiver 1. Set up the components (a) displaying Onkyo's R I mark. 2. Connect TX-SV828THX to the power amplifier. ( ) 3. Connect the speaker B cables to the speaker terminal on the power amplifier. 4. Install Connecting Block 789-40 in the main room, then connect it to the TXSV828THX. (4)) Pnvx=r supply 2. Power amplifier 3. Speaker (Sub room) 3. Speaker N (Sub room) (Connect Power Supply 781C-00 to the Connecting Block.) 5. Install Xantech's J-Box Receiver 78010 or Dinky Link 480B-00 in the subroom, then connect it to the Connecting Block in the main room. GO B. Using a remote control to operate components not displaying Onkyo's RI mark from the sub-room 3. Emitter Q (c) MAIN ROOM 5. Emitter (e) 4. Components(d) Connecting block TX-SV828THX 1. Components(b) Speaker H Speaker (Main room) (Main room) Power , supply Power amplifier SUB ROOM -Remote control Dinky Link or J-Box Receiver Speaker (Sub room) Speaker (Sub room) N 1 1. Connect the components (b) to the TX-SV828THX. 2. Make the connections described above in steps 2 through 5 of section A. 3. Install Emitter 282-00 (c) so that its sensor is directed toward these components, then connect it to the TXSV828THX. ( II Operating components which are positioned out of the range of the emitter installed as described above 4. Connect the components (d) to the TX-SV828THX. 5. Install another Emitter 282-00 (e) so that its sensor is directed toward these components, then connect it to the Connecting Block 789-40. (6') Connection diagram MULTI SOURCE PRE OUT= TX-SV828THX Gray Terminal MRx IN g FOOOOOOO 00 I 46151 OOOOOO 000000 00 FRONT SPEAKERS OUT A 000000 00000 00000000000 00000000000 Connecting block 789-40 Emitter 282-00 I 0 Power supply 781C-00 0 0 0 0 Speaker (Main Room) 18 Power Amplifier SPEAKERS -O -e 0 - Main IN - 0 0 - LJ- 6.8 all Speaker (Sub Room) MO ....... 0 0 0 IA 14 Dinky link 480B-00 or J-Box Receiver 780-10 SUB ROOM 11¢ 91 g 111