Onkyo TX-SV828THX Owner Manual - Page 21

USE PAZ;g:el KEYS 'SESITINg A or B IIIMINIMMIENNIN LEARN PRESS MA USE LEA, LEARNED SF 'MING Operating the remote control • Please check whether previously memorized functions are working properly. If the LEARNED/SENDING indicator is not illuminated when a programmed button is pressed, it may need to be relearned from your existing remote control. I. Set the USE/LEARN selector switch to USE position. 2. Set the A/B/C (SUB ROOM) selector switch to the desired posi- tion. Then operate the remote control by pressing the button of the functions you want to use. • There is no power switch for the remote control, as power is supplied automatically when a button is pressed. If no button is pressed for a short interval, power goes off automatically, to avoid wasting the battery. • If you press a button for which no code has been memorized, the LEARNED/SENDING indicator will not light up. Changing commands 1. Set the USE/LEARN selector switch to LEARN. 2. Commands should be memorized using the method outlined in the section "r ear,-,,,,g" new controller codes. • Entering new codes for certain buttons does not affect the func- tions of the other memorized buttons. 1 2 LEARN PRESS % ICR!. hEYS USL LEARN LEARNED SENDING 3 4 A or B 4, 5 "RESET" switch How to reset the RC-307M (Clearing all memorized command) 1. Switch the USE/LEARN selector switch to LEARN. 2. Switch A/B/C (SUB ROOM) selector switch to A or B you want to reset. 3. Remove the battery compartment cover. 4. Press the button you want to delete to light up PRESS MATCH- ING KEYS indicator. 5. Use the tip of a pointed instrument, such as a ball-point pen, to press the Reset switch (indicated by the RESET in the battery case), then release the switch when the PRESS MATCHING KEYS indicator goes out. The reset operation is completed. 6. Repeat step 4 to 5 to reset other buttons if desired. 7. Attach the battery compartment cover again. • If there are preset ONKYO codes, the preset codes will be recalled. If the indicators flash During learning, the both indicators flash if the codes being learnt are unstable and cannot be memorized properly. This is because the RC-307M requires highly stable transmission output for identifying codes. To ensure the reception of stable codes, place both remote control on a table or other level surface and position them at a fixed distance and orientation, facing each other. Another possible reason for unstable transmission codes is worn-out batteries on the existing remote control. Replace the batteries of the existing remote control with new ones, then repeat the learning operation. If the both indicators flash when a button is pressed on the RC-307M, it means that the RC-307M batteries are worn out. Replace its batteries with new ones. 21