Onkyo TX-SV828THX Owner Manual - Page 26

Listening to your favourite source POWER MASTER VOLUME •• $ IL I I O FIEI71 = 0 O (O O O) Fri==== O O O SPEAKERS A, B DIMMER POWER SLEEP DIMMER .1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 iii o o o =I. ONICIFO RI AUDIO MUTING 26 Explanation of the buttons Power button (POWER) and STAND-BY/RECEIVED indicator The STAND-BY/RECEIVED indicator comes on when the AC power cord for this unit has been inserted in an outlet. This indicates that this unit is standing by for operation. Press the power button will turn the main unit on, then this indicator goes off. The indicator also lights when a signal is received from the remote control. Speaker selector buttons (SPEAKERS A/B) and indicators You can operate the Speaker selector. When A or B is on, the A or B SPEAKERS indicator will light. When SPEAKERS A is selected, sound will come from the front left and right, center and left and right surround speakers at the same time. NOTE: A and B can not be turned on at the same time. Master volume control knob (MASTER VOLUME) With a correctly calibrated system, the 0 dB position corresponds to the same volume level that is heard in a film mixing room when producing the soundtrack. Use the master volume control knob to adjust the volume of the Front Left and Right, Center and Surround Left and Right speakers and the pre out levels (not including the multi source pre out level) at the same time. Turn clockwise to increase the volume level. The volume can be adjusted manually and by the remote control's VOLUME A/V buttons. The Master Volume level can be set from -oodB(minimum), -60...-I, 0, +1....+18dB(maximum) and the level is shown on the display. NOTE: Depending on the channel level setting, it may be impossible to set the Master Volume level to +18dB. Even if the Master Volume knob is manually turned to its maximum, it will return to its highest possible setting. Use the remote control to adjust the multi-source level. (Refer to page 51 for details.) Audio muting button (AUDIO MUTING) (Remote control only) This button temporarily switches off the sound from the speakers, pre out or headphones by operating the TX-SV828THX audio muting circuits. The audio muting indicator MUTING will flash. Pressing the button again or using the POWER button to turn the power off and on will turn off the audio muting. Audio muting using this button does not affect the sound of the multi source. Dimmer button (DIMMER) This button can be used to change the brightness of the display. The display brightness changes in four steps (bright, medium, dim and off). If the display is turned off and a function is set, the display will turn off after being lit for a few seconds. Sleep button (SLEEP) Press to set the power-off timer. The sleep timer is a function which turns off the power to the system after a certain period from the time it is set. When this button is pressed, "90 MIN- is displayed for 5 seconds, and the power will go off 90 minutes later. Each time the button is pressed during 5 seconds, the timer setting changes by 10 minutes e.g. 80, 70, 60 ... While the sleep timer is operating, the SLEEP indicator is lit. If the sleep button is pressed during this time, the amount of time remaining on the timer is displayed, and if the button is pressed during that display, 10 minutes will be subtracted from that time. If the button is pressed when the panel display shows 10 minutes or less, the sleep timer is cancelled, and the power is not turned off.