Panasonic CF-F8 User Manual - Page 26
Shutting Down, Password, Display, Battery, Starting Up and Standby and Hibernation Mode - windows 7
View all Panasonic CF-F8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Troubleshooting Useful Information Getting Started Troubleshooting (Basic)/Error Code/Message Starting Up and Standby and Hibernation Mode Cannot resume. z One of the following operations may have been carried out. • In standby mode, the AC adaptor or battery pack was disconnected, or a peripheral was connected or disconnected. • The power switch was slid for four seconds or longer to forcibly turn off the computer. Slide the power switch to turn on the computer. Data not saved will be lost. Other startup problems. z Check to see if there was a disk error. A Remove all peripheral devices including an external display. B Click [start] - [My Computer] and right-click [Local Disk (C:)], and click [Properties]. C Click [Tools] - [Check Now]. • A standard user needs to enter an administrator password. D Select the option in [Check disk options] and click [Start]. z Start the computer in Safe Mode and check the error details. (Î page 25 "Windows does not start up".) Shutting Down Windows does not shut down. z Remove all peripheral devices. z Wait one or two minutes. It is not a malfunction. Password Even after entering the pass- z If word, a message appears requesting to type it again. z If lights up, press NumLk to disable the ten-key mode, and then input. lights up, press Caps Lock to disable the Caps Lock mode, and then input. Display When the screen becomes black for a moment. No display. The screen is disordered. The external display does not work normally. z When you set [Intel video driver power saving function (Intel(R) Display Power Saving Technology)] of Power Saving Utility to [Enabled], if you do the following operations, the screen becomes black for a moment, but this is not a malfunction. You can use it. • Adjust the brightness of the screen with Fn + F1 / Fn + F2. • Remove and insert the AC adaptor. While you are using motion video playback software, benchmark software for graphic, if error screen is displayed or application software does not function normally, set [Intel video driver power saving function (Intel(R) Display Power Saving Technology)] to [Disable]. z The external display is selected. Press Fn + F3 to switch the display. Wait until the display has been switched completely before pressing Fn + F3 again. z The display is turned off by the power-saving function. To resume, do not press the direct selection keys, but press any other key like Ctrl. z The computer entered standby or hibernation by the power-saving function. To resume, slide the power switch. z The screen may become darker. Press Fn + F2 to make the screen brighter. z Changing the number of display colors and resolution may affect the screen. Restart the computer. z The refresh rate of the internal LCD may be 40 hertz. Change the refresh rate of the internal LCD. A Click [start] - [Control Panel] - [Other Control Panel Options] - [Intel(R) GMA Driver for Mobile]. B Click [Display Settings]. C If [Refresh Rate] of the Notebook is [40 Hertz], change to [60 Hertz] and click [OK]. z If the external display does not support the power saving function, it may not work normally when the computer enters the power saving mode. Turn off the external display. Battery The battery indicator is lights red. z The battery level is very low (the charge is approx. 9% or less). z Connect the AC adaptor. You can use the computer when the indicator light is orange. If you do not have an AC adaptor, save your data and power off your computer. After replacing the battery pack with a fully charged one, turn your computer on again. Appendix 26