Panasonic CF-F8 User Manual - Page 3
Read Me First - troubleshoot
View all Panasonic CF-F8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Read Me First Troubleshooting Useful Information Getting Started Models for U.S.A. Federal Communications Commission Radio Fre- This device complies with Part 15 of the FCC Rules. quency Interference Statement Operation is subject to the following two conditions: Note: This equipment has been tested and found to com- (1)This device may not cause harmful interference, and ply with the limits for a Class B digital device, pursuant to (2)This device must accept any interference received, includ- Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. ing interference that may cause undesired operation. Responsible Party: Panasonic Corporation of North America One Panasonic Way Secaucus, NJ 07094 Tel No:1-800-LAPTOP5 (1-800-527-8675) However, there is no guarantee that interference will not 6-M-1 occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment FCC Regulation Notice for modem This equipment contains a FCC approved modem. off and on, the user is encouraged to try to correct the interference by one or more of the following measures: z Reorient or relocate the receiving antenna. z Increase the separation between the equipment and receiver. z Connect the equipment into an outlet on a circuit differ- ent from that to which the receiver is connected. z Consult the Panasonic Service Center or an experi- enced radio/TV technician for help. Warning To assure continued compliance, use only shielded interface cables when connecting to a computer or peripheral. Also, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. 1. This equipment complies with CFR47 Part 68 rules. On the computer is a label that contains, among other information, the FCC registration number and ringer equivalence number (REN) for this equipment. If required, this information must be provided to the telephone company. 2. An FCC compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be connected to the telephone network or premises wiring using a compatible modular jack which is Part 68 compliant. See Installation Instructions for details. FCC RF Exposure Warning: z This computer is provided with a PC Card slot that could be used with wireless transmitter(s), which will be specifically recommended, when they become available. Other third-party wireless transmitter(s) have not been RF exposure evaluated for use with this computer and may not comply with FCC RF exposure requirements. z This equipment complies with FCC radiation exposure 3. The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all area, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. 4. If your telephone equipment cause harm to the tele- limits set forth for an uncontrolled environment. z This equipment must be installed and operated in accordance with provided instructions and minimum 1.5 cm spacing must be provided between antenna and all person's body (excluding extremities of hands, wrist and feet) during wireless modes of operation. z This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. 25-M-2-3 This product is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency range. phone network, the telephone company will notify you in advice that temporary discontinuance of service may be required. But if advice notice isn't practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. 5. The telephone company may take changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service. 6. If trouble is experienced with this equipment, for repair FCC requires this product to be used indoors for the fre- or warranty information, please contact Panasonic quency range 5.15 to 5.25 GHz to reduce the potential for harmful interference to co-channel Mobile Satellite systems. High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause interference with and /or damage this product. Corporation of North America at DIAL TOLL FREE 1800-LAPTOP5 (1-800-527-8675). If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved. 7. There are no user serviceable parts contained in this equipment. 25-M-W-1 3 Appendix