Panasonic CYVHD9500U CYVHD9500U User Guide - Page 12
Monitor Position/Adjustment, Remote Control Unit Preparation - install
View all Panasonic CYVHD9500U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
E N G Monitor Position Adjustment L I S H Open the Display Unit Display Unit Lateral Angle 7 (PUSH OPEN) Adjustment Maximum 120e 30e 30e 1 Push the display release button (PUSH OPEN) until the display is unlocked. (Press the button with one hand while holding the display with the other.) 2 Open the display unit by both hands until a comfortable viewing angle is reached. Close the Display Unit Move the display unit by both hands until the display release button is locked. Note: ≥ Always use both hands to open or close the display unit. ≥ Always check that the display release button is locked after closing the display unit. ≥ If the display unit cannot be locked, be sure to consult your dealer and remedy the situation. You can swivel it to the left and right, 30˚ each way. Hold the display unit by the non-slip part in the upper half of it and adjust its lateral angle. 50 CY-VHD9500U Remote Control Unit Preparation E N G L I S Battery Installation Battery Notes H 1 Remove the battery holder. ≥ Battery type: Panasonic lithium battery 8 With the remote control unit placed on a flat (CR2025/1F) (supplied) surface: ≥ Battery life: Approximately 6 months under 1 Stick your thumbnail into the groove, and normal use (at room temperature) push the holder in the direction of the arrow, and at the same time 2 Pull it out in the direction of the arrow using a tough pointed object. Caution: ≥ Improper use of the battery may cause overheating, an explosion or ignition, resulting Tough pointed object in injury or a fire. Battery leakage may damage Back side the product. ≥ Do not expose the remote control unit to direct sunlight. ≥ Do not recharge, disassemble, deform or heat the battery. ≥ Do not put the battery in fire or water. ≥ Immediately replace used up battery. ≥ Obey local ordinances when disposing of the battery. Note: ≥ To ensure that the remote control unit is not lost or misplaced, use the accessory magic tape ("Velcro") to secure it at a safe place. 1 2 2 Install the battery on the battery holder. Set a new battery properly with its (+) side facing up as shown in the figure. 3 Insert the battery holder back into its original position. Lithium battery (supplied) 2 magic tape ("Velcro") (supplied) ≥ Remove all oil, water, surfaces where the magic tapes are to be attached. 3 Battery holder CY-VHD9500U 51