Panasonic DMREZ17K Dvd Recorder - Page 63

Error Messages On the Unit's Display H ,F (" " stands for a service number.) RC (" " stands for a number.) HARD ERR ("HArd" and "Err" are alternately displayed.) NO READ ("NO" and "REAd" are alternately displayed.) FULL UNSUPPORT ("UNSUP" and "POrt" are alternately displayed.) UNFORMAT ("UNFOr" and "MAt" are alternately displayed.) U59 U61 U88 U99 • An error has occurred. The number following "H" or "F" depends on the status of the unit. Check the items below and in the Troubleshooting Guide. If the service number still does not disappear after the check, reset the unit (➔ 55, "To restore the unit if it freezes" ). • If the service numbers fail to clear, note the service numbers and contact a qualified service person. • The remote control and main unit are using different codes. Change the code on the remote control. • If there is no change after turning the unit on and off, consult the dealer where the unit was purchased. Page − − 55 − • The disc is dirty or badly scratched. The unit cannot record, play, or 53 edit. • The disc may be incompatible or of poor quality. 53 • You have used a lens cleaner and it has finished operation. Press 3 [; OPEN/CLOSE] on the main unit to eject the disc. • Displayed when the unit is started. This is not a malfunction. − • The unit is carrying out its recovery process. You cannot operate the − unit while " " is displayed. • There are already 16 scheduled recording programs. Delete 15 unnecessary scheduled recording programs. • You have inserted a disc the unit cannot play or record on. 53 • You have inserted a new DVD-RW/+RW or a DVD-RAM/DVD-RW 28 (DVD-Video format) recorded on other equipment. You can format the disc when the format confirmation screen is displayed. • The unit is very warm. − The unit switches to standby for safety reasons. Wait for about 30 minutes until the message disappears. Reinstall the unit in an area with adequate ventilation. Do not block the cooling fan on the rear of the unit. • There was a power failure or the AC power supply cord was − disconnected while the unit was on. The unit is carrying out its recovery process. This process restores the unit to normal operation. The unit is not broken. Wait until the message disappears. • There was something unusual detected with the disc while recording, 57 playing; there was a power failure or the AC power supply cord was disconnected while the unit was on. The unit is carrying out its recovery process. This process restores the unit to normal operation. The unit is not broken. Wait until the message disappears. • The unit fails to operate properly. Press [POWER ^/I] on the main − unit to switch the unit to standby. Press [POWER ^/I] on the main unit again to turn the unit on. Reference 63 RQT8850