Panasonic GPUS932CU GPUS932CU User Guide - Page 19

3. Electronic shutter setting [SHUTTER] The electronic shutter speed is specified. The speed is selectable from the following. OFF (default),1/100 (1/120*), 1/250, 1/500, 1/1000, 1/2000, 1/4000, 1/10000, and MANU Select "MANU", and press [SEL] button. The "SHUTTER" screen appears to adjust the shutter speed in detail. Adjustable speed range: 3/562 (2/562*) - 552/562 * The value is for GP-US932CUE/GP-US932CUSE. "SHUTTER" screen ** SHUTTER ** MANU SET 552/562 RET END Note: • When the shutter speed is specified, be sure to set both "ELC" and "SENS UP" to "OFF". ( pages 18 and 19) 4. Gain adjustment [GAIN] The gain adjustment is selectable from the following. OFF (default): The gain is not adjusted. AUTO (L), AUTO (H): The gain is automatically adjusted. MANU (L), MANU (H): The gain is manually adjusted. The gain level is adjusted in detail. The gain can be finely adjusted in the "LOW" and "HIGH" levels. z Select an adjustment in "GAIN" and press the [SEL] but- ton. → The "GAIN LEVEL" screen appears. x Move the cursor to "HIGH" or "LOW" and adjust the level with use of the [e] or [f] button. "GAIN LEVEL" screen ** GAIN LEVEL ** LOW -...|.....+ HIGH -........|+ Important: • The "LOW" level cannot be larger than the "HIGH" level. • When "SENS UP" is set to "OFF" or "---", "AUTO (L)" is not available. 5. Electronic sensitivity enhancement setting [SENS UP] The magnification of the electronic sensitivity is selectable from the following. OFF (default), AUTO (x2), AUTO (x4), AUTO (x8), MANU (x2), MANU (x4), and MANU (x8) Notes: • When "MANU (x2)", "MANU (x4)", or "MANU (x8)" is selected, be sure to set "ELC" to "OFF". ( page 18) • When "GAIN" is set to "OFF" or to a low level, video may become grainy and unstable. In such a case, adjust the electronic sensitivity. • When "SHUTTER" is set to other than "OFF", "---" appears and electronic sensitivity enhancement function is not available. • When the electronic sensitivity enhancement function is used, time for CCD readout is elongated to enhance the sensitivity. Therefore, the residual image of a moving subject is increased in accordance with the magnification of the sensitivity. 6. Output signal setting [OUTPUT SEL] The output signals of RGB/YPbPr output connector, HDMI output connector are specified. Output signals vary with models. GP-US932CU, GP-US932CUE (HDMI output connector equipped): RGB (NOR) (default), RGB (ENH), YPbPr (422), YPbPr (444)* * The output signal of the RGB/YPbPr output connector is the same in both RGB (NOR) and RGB (ENH) and in both YPbPr (422) and YPbPr (444), respectively. GP-US932CUS, GP-US932CUSE (SDI output connector equipped): RGB (default), YPbPr RET END 19