Panasonic PT-50LC13 Multi-media Display - Page 23

Turning the Power ON and OFF Power ON / OFF Always be sure to follow the procedure given below to turn the projection display power ON and OFF. • The lamp cooling fan will continue to operate for approximately 1 minute after the power is turned off. At the same time, the POWER indicator will blink Red. Do not disconnect the power cord from the outlet and do not open the circuit breaker (unless necessary) while the cooling fan is still operating. Do not disconnect the power cord from the power outlet while the power indicator blinks Red. POWER button/ POWER indicator Power ON Press POWER on projection display or remote control to turn power on. The Power Indicator blinks Green for about 10 seconds and then turns solid Green. Power OFF Press POWER on projection display or remote control to turn power off. Power shuts off after a Black Screen is displayed for a few seconds. Note: If POWER is pressed during the Black Screen display, Power is turned back on. The Power Indicator blinks Red for about 1 minute and then turns solid Red. Basic Operation Note: When the AC Cord is unplugged, the internal cooling fan stops operating. In this case, the lamp will be insufficiently cooled and will take a while to turn ON again. The Power Indicator LED Red Red blink Green Green blink ACTION Power - OFF (Standby mode) Power - OFF (Now cooling) Power - ON Power - ON (Preparing to light lamp) Notes: • If the POWER button is accidentally turned off during use, after power is turned back on, it may take a short period before the lamp automatically comes on. • After the unit is turned on, maximum picture brightness will be achieved in 5-10 minutes. This is normal. 23