Panasonic PT AE700U Lcd Projector - Page 27
AA BB, Care and maintenance, Lamp unit replacement procedure - lamp replacement
UPC - 410000150467
View all Panasonic PT AE700U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
On-screen display LAMP indicator Displayed for 30 More than 2 700 hours* seconds. Pressing any button will clear the Illuminates red during display. image projection and standby mode. More than 3 000 hours* Remains displayed until any button is pressed. * These periods of time may become shorter according to the settings of the projector. Lamp unit replacement procedure NOTE: B If the lamp usage time has passed 3 000 hours (when "LAMP POWER" has been set to "HIGH" and when "DYNAMIC IRIS" has been set to "ON"), the projector will switch to standby mode after approximately 30 minutes of operation. The steps ) to - on the next page should thus be completed within 30 minutes. # Turn off the MAIN POWER switch according to the procedure given in "Turning off the power" on page 26, and then disconnect the power cord plug from the wall outlet and check that the area around the lamp unit has cooled down. $ Use a Phillips screwdriver to turn the lamp unit cover fixing screws at the bottom of the projector, and then remove the lamp unit cover. % Use a Phillips screwdriver to loosen the two lamp unit fixing screws until the screws turn freely. Then hold the handle of the lamp unit and gently pull it out from the projector. Lamp unit fixing screws A B Lamp unit cover Lamp unit cover fixing screws 52-ENGLISH Handle & Insert the new lamp unit while making sure that the direction of insertion is correct, and then use a Phillips screwdriver to securely tighten the lamp unit fixing screws. When inserting the new lamp unit, be sure to push it in at the point A and B . ' Install the lamp unit cover, and then use a Phillips screwdriver to securely tighten the lamp unit cover fixing screws. ( Insert the power cord plug into the wall outlet and then press the MAIN POWER switch. ) Press the POWER button so that a picture is projected onto the screen. * Press the MENU button to display the "MAIN MENU", and then press the F or G button to select "OPTION". MENU KEYSTONE PICTURE POSITION SHUTTER LANGUAGE OPTION SELECT ENTER EXIT + Press the ENTER button to display the "OPTION" menu, and then press the F or G button to select "LAMP RUNTIME". OPTION OSD ON NR ON CINEMA REALITY ON BACK COLOR BLUE WSS ON FRONT/REAR FRONT DESK/CEILING DESK FAN CONTROL NORMAL LAMP POWER HIGH LAMP RUNTIME 2720H SELECT ESC , Press and hold the ENTER button for approximately 3 seconds. OPTION OSD ON NR ON CINEMA REALITY ON BACK COLOR BLUE WSS ON FRONT/REAR FRONT DESK/CEILING DESK FAN CONTROL NORMAL LAMP POWER HIGH TIME RESET [POWER OFF] SELECT ESC The "LAMP RUNTIME" will change to "TIME RESET [POWER OFF]". B If the MENU button is pressed, the lamp time resetting screen will be cancelled. - Turn off the power. This will reset the cumulative usage time for the lamp unit to zero. Refer to page 26 for details on how to turn off the power. NOTE: B Be sure to install the lamp unit and the lamp unit cover securely. If they are not securely installed, it may cause the protection circuit to operate so that the power cannot be turned on. ENGLISH-53 Care and maintenance