Panasonic TH-47LFX6 Operating Instructions - Page 21

PC Input Terminals connection Connections (Female) Conversion adapter (if necessary) COMPUTER RGB Mini D-sub 15p (Male) Connect a cable which matches the audio output terminal on the computer. Audio Stereo mini plug (M3) Shared with DVI-D IN. Notes: • Computer signals which can be input are those with a horizontal scanning frequency of 30 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.) • The display resolution is a maximum of 1,440 × 1,080 dots when the aspect mode is set to "4:3", and 1,920 × 1,080 dots when the aspect mode is set to "16:9". If the display resolution exceeds these maximums, it may not be possible to show ¿ne detail with suf¿cient clarity. • The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will need to make setting changes to the computer at the time of connection. • Some PC models cannot be connected to the set. • There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal. • The computer shown in the illustration is for example purposes only. • Additional equipment and cables shown are not supplied with this set. • Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the speci¿ed frequency range. Signal Names for Mini D-sub 15P Connector 11 12 13 14 15 6 7 8 9 10 123 45 Pin No. 1 2 3 Signal Name R G B Pin No. 6 7 8 Pin Layout for PC Input Terminal 4 NC (not connected) 9 5 GND (Ground) 10 Signal Name GND (Ground) GND (Ground) GND (Ground) +5 V DC GND (Ground) Pin No. Signal Name 11 NC (not connected) 12 SDA 13 HD/SYNC 14 VD 15 SCL 13