Panasonic VDR M50 Dvd Camcorder - Page 48

Removing Disc, Press down the DISC EJECT

Page 48 highlights

Removing Disc 1 Set the power switch to "OFF" to turn the DVD Video Camera off. 2 Press down the DISC EJECT lever once and release it. In a moment, the cover of disc insertion compartment will open slightly. DISC EJECT 3 Gently open the cover until it stops. When the cover is fully open, the disc will slightly come out from the disc guide, and stop. Note: • Even after the DVD Video Camera is turned on, the disc can be removed unless it is in recording status. Hold down the DISC EJECT lever for approximately 2 seconds, and then release it to remove the disc. (The DISC EJECT indicator on the LCD screen will blink.) It is recommended that you turn the DVD Video Camera off before inserting or removing disc to prevent misoperation. • Do not remove the battery pack or disconnect the AC adaptor during removal of the disc or until power is completely turned off: If you do, the disc cover will not open. If this happens, reattach the battery pack or AC adaptor, push down the DISC EJECT lever once, and then release it. • Do not insert anything other than the 8 cm DVD-RAM or DVD-R disc into the disc insertion block: Doing so could cause malfunctions. • Set the power switch to "OFF" to turn the DVD Video Camera off. • When inserting or removing the disc, be careful not to touch the inside of DVD Video Camera [especially, the lens of laser pickup (see "Terminology" on page 148 )]. • When inserting or removing the disc, connect a charged battery pack or AC adaptor to the DVD Video Camera: The disc cover will not open unless the DVD Video Camera is powered. 4 Remove the disc. Hold the top of Round DVD Holder as shown in the illustration and gently pull it out. Note: Be careful not to touch the exposed disc portion when removing the disc. When grasping the holder, avoid the exposed disc portion. 5 Gently push the section indicated "PUSH CLOSE" on the cover of disc insertion compartment (on side) to close the cover. 48

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174

48
Removing Disc
1
Set the power switch to “OFF”
to turn the DVD Video Camera
off.
2
Press down the DISC EJECT
lever once and release it.
In a moment, the cover of disc
insertion compartment will
open slightly.
3
Gently open the cover until it
stops.
When the cover is fully open,
the disc will slightly come out
from the disc guide, and stop.
4
Remove the disc.
Hold the top of Round
DVD Holder as shown in
the illustration and
gently pull it out.
Note
:
Be careful not to touch the
exposed disc portion
when removing the disc.
5
Gently push the section
indicated “PUSH
CLOSE”
on the cover of disc insertion
compartment (on side) to
close the cover.
Note
:
Even after the DVD Video Camera is turned on, the disc
can be removed unless it is in recording status. Hold
down the DISC EJECT lever for approximately 2
seconds, and then release it to remove the disc. (The
DISC EJECT indicator on the LCD screen will blink.) It is
recommended that you turn the DVD Video Camera off
before
inserting
or
removing
disc
to
prevent
misoperation.
Do not remove the battery pack or disconnect the AC
adaptor during removal of the disc or until power is
completely turned off: If you do, the disc cover will not
open. If this happens, reattach the battery pack or AC
adaptor, push down the DISC EJECT lever once, and
then release it.
Do not insert anything other than the 8 cm DVD-RAM or
DVD-R disc into the disc insertion block: Doing so could
cause malfunctions.
Set the power switch to “OFF” to turn the DVD Video
Camera off.
When inserting or removing the disc, be careful not to
touch the inside of DVD Video Camera [especially, the
lens of laser pickup (see “Terminology” on page 148 )].
When inserting or removing the disc, connect a charged
battery pack or AC adaptor to the DVD Video Camera:
The disc cover will not open unless the DVD Video
Camera is powered.
DISC EJECT
When grasping the holder,
avoid the exposed disc
portion.