Panasonic WJND200 WJND200 User Guide - Page 82

Symptom Refresh of live images is unstable. Browser disconnection sometimes occurs. Network performance is poor. Image file downloaded from the FTP server is faulty. Cannot operate the camera. The setup menu of the camera is not displayed even though the [SETUP] button on the "NW Camera Setup" page is clicked. Cannot format the hard disk using the FORMAT button inside the front cover. 82 Cause/solution Reference pages • When the image compression method of all cameras in use is not the same, performance may become - lower. (Refresh of images will be unstable.) • The configured settings for transmission rate/record- ing rate may be beyond the maximum network perfor- mance. Lower the value/rate of the settings relating to the net- 43 work such as the transmission rate, recording rate, etc. • The line speed settings may be not the same between the unit and the hub, for example, 100M BASE-TX Full for the unit and 100M BASE-TX half, etc. Some hubs change the line speed automatically depending on the network traffic and it may cause configuration - errors. Check the line speed settings of both the unit and the hub, and configure the line speed settings of both to conform them. • Are the settings of the network camera set correctly? Check the model of the set camera on the setup 47 menu ("Camera" - "NW Camera Setup"). • Are the user ID and the password for the network camera set correctly? Check if the user ID and password are set correctly 50 on the setup menu ("Camera" - "NW Camera Setup"). • Change the port number for the camera, and then click the [SETUP] button again. 50 • Is "ON" selected for "Enable format button" on the "Config" page? When "OFF" is selected, it is impossible to format the 76 hard disk using the FORMAT button. Check the "Enable format button" setting on the "Config" page.