Panasonic WV-CS954 Operating Instructions - Page 14
RS485 Communication Parameters DIP Switch 1
View all Panasonic WV-CS954 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
DIP Switch 1 Unit Number DIP Switch 1 Unit Number DIP Switch 1 Unit Number ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 69 70 71 72 73 74 75 76 77 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 78 79 80 81 82 83 84 85 86 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 ON 12345678 87 88 89 90 91 92 93 94 95 * When using the Unit Number 1 to 96 setting, the unit number setting needs to be configured using the RS485 SET UP menu. For details about configuring this setting, see step 2 and page 20. * Turning on power when this setting is selected causes the RS485 SET UP menu to appear during the initialization routine. ■ RS485 Communication Parameters (DIP Switch 1) Configuring DIP Switch 1 as shown below resets communication parameters to their factory default settings. You can then change the settings as desired. DIP Switch 1 ON 12345678 ON 12345678 ON 12345678 ON 12345678 Setting Description This setting resets communication parameters to the factory default settings. BAUD RATE : 19 200 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bit BAUD RATE : 9 600 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bit BAUD RATE : 4 800 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bit Perform the following steps to use this setting. (1) Turn off the camera and use DIP Switch 1 to configure RS485 communication parameters as shown above. (2) Turn on the camera. This applies the setting you configured in step (1). (3) Turn off the camera, use DIP Switch 1 to set the unit number (pages 13 and 14), and then turn the camera back on again. -14-