Panasonic WV-CS954 Operating Instructions - Page 22

CAMERA SETTINGS ■ Using the Camera Setup Menu Display the camera setup menu from the setup menu to configure camera settings. First, display the camera setup menu. 1. Display the setup menu (page 21), move the cursor to CAMERA O, and then press the CAM (SET) button. This will display the camera setup menu. **CAMERA SETUP** 1/2 CAMERA ID OFF ALC/MANUAL ALC SHUTTER AUTO AGC ON(MID) SENS UP OFF SYNC INT WHITE BAL ATW1 DNR LOW RESOLUTION HIGH BW MODE AF MODE AUTO L q e t u o !1 w r y i !0 **CAMERA SETUP** 2/2 ZOOM LIMIT ×30 STABILIZER OFF !2 !3 CAMERA ID--0123456789 ABCDEFGHIJKLM NOPQRSTUVWXYZ SPACE ---- POSI RET RESET DOOR............ Camera ID Input area 4. Move the cursor to POSI, and then press the CAM (SET) button. This will display the ID position setting menu. 5. Use the joystick to select a camera ID display position, and then press the MON (ESC) button. This registers the camera ID display position and returns to the camera setting menu. RET TOP DOOR * The following sections numbered q to !3 explain how to use each of the camera setup menu items. (1) Camera ID (CAMERA ID) The camera ID is a series of alphanumeric characters that indicate the location of the camera. This item can be used to turn display of the camera ID on the monitor screen on or off, and to input the camera ID. 1. Move the cursor to CAMERA ID, and then tilt the joystick left or right to toggle camera ID display on and off. 2. Select ON or OFF, and then press the CAM (SET) button. 3. Use the joystick to move the cursor the character you want to input, and then press the CAM (SET) button. This will cause the selected character to appear in the camera ID input area. Repeat step 3 as many times as necessary to input all of the characters for the camera ID. (Example: DOOR) To input a blank space Move the cursor to SPACE, and then press the CAM (SET) button. To delete previously input characters Move the cursor to RESET, and then press the CAM (SET) button. To change previously input characters Use the joystick to move the cursor to the camera ID input area. Next, tilt the joystick left and right to move the ↑ pointer to the character you want to change. Finally, use step 3 above to input the new character. (2) Light Control (ALC/MANUAL) 1. Move the cursor to ALC/MANUAL, and then tilt the joystick left or right to toggle between ALC and MANUAL. ALC : Enables automatic lens iris adjustment in accordance with subject brightness. Select this ALC when using SUPER-D 3. MANUAL: Adjust the lens iris with the IRIS button on the system controller. Fixes the lens iris. Note: The backlight compensation submenu associated with this menu is described separately and should be set up after installing the camera at the site and observing the actual site picture. 2. If ALC is set in step 1, press the CAM (SET) button to set SUPER-D 3. SUPER-D 3 (Super Dynamic 3) When there is wide variation between the illumination of light and dark areas of the location being monitored, the camera adjusts the lens iris in accordance with the bright areas. This causes loss of detail in dark areas. Conversely, adjusting lens brightness for the dark areas cause brighter area to become washed out. SUPER-D 3 digitally combines an image that is set up for a clear view of bright areas with an image that is set up for a clear view of dark areas, creating a final image that preserves overall detail. -22-