Panasonic kx-tg2267 2.4 Ghz Cordles Phon - Page 46

Voice Mail Service Setting the Voice Mail (VM) Tone Detection Your telephone company sends special signals (Voice mail tones) to activate the VM indicator. Press or to listen to the dial tone. If you hear a series of dial tones followed by a continuous dial tone, this is indication that a new message was recorded. Your phone comes set to detect these tones (set to "On"). Minutes after you hang up or after the phone stops ringing, your unit will seize the phone line and check if a message has been recorded. If a new message was recorded at your telephone company, "Voice mail" will be displayed on the handset and the base unit VM indicator will flash. Set this programming to "Off" when: -you do not subscribe to a voice mail service, -your telephone company does not send a series of tones, followed by a continuous tone, or -your phone is connected to a business or office telephone system (PBX). Please refer to below to set this programming to OFF. If you are not sure which setting is required, consult your local telephone company or contact Panasonic Customer Call Center. Make sure the unit is not being used and the handset is lifted off the base unit. 1 Press (HOLD/FUNCTION/CLEAR). 2 Scroll to "Program" by pressing Ö or Ñ, and press á. 3 Scroll to "VM tone detect" by pressing Ö or Ñ. Save VM acces# HVM tone detect Set line mode 4 Press á. 5 Press Ö (Line 1) or Ñ (Line 2) to select the line. •The line's current setting will be displayed. 6 Select "Off" or "On" by pressing Ö or Ñ. VM tone detect G=Line1 F=Line2 VM tone detect Line1:On GF H=Save VM tone detect Line1:Off 7 Press á (Save key). •A beep sounds. •To program the other line, start again from step 3. •To exit the programming mode, press (OFF). •You can exit the programming mode any time by pressing (OFF). 46