Pfaff Tiptronic 1171 Owner's Manual - Page 32

Controls of the electronic system Needle positions "up" and "down" After sewing the needle is always retained at its 'up" position. When you press the "needle down" button, iadicator light N lights up and the needle remains down in the fabric (for sewing corners end turning the fabric( whenever sewing is interrupted. When you press the button again, the indicator light goes out, the needle moves upwards and is retained in its "up" position whenever the machine stops. The button can be pressed during sewing. Electronic top speed selection By pressing the "sew slow" button, the top speed of your machine can be halved. At the same time indicator light 0 lights up. When you press this button again, the indicator light goes off and the machine speed can be varied at will. The full pier cing power of the needle remains the same at any speed. Basting Press the basting stitch button. The green indicator lamp P lights uo. Drop the machine feed (page 4-) anJ screw on the darning foot (page 391. Place the fabric under the sewing foot. Each time 'iou press and release the foot pedal the machine sews one stitch. Move the fabric under the sewing foot unt I the length of stitch rertuired is obtained, then holding the fabric in this 05itiOfl, press down the foot pedal and release it again. Repeat this operation for each basting stitch. When you have finished basting move your foot from the pedal and press nesting st:tch button again Tne green indicator lame P goes out. Push the drop- feed control to the left again Close free arm cover 121. Electronic bobbin thread monitor The red moritor signal lamp Ill starts to of bobbin thread flash when the bobbin thread is running out. Tne lOmp goes out when a full bobbin is inserted and sewing Continues. Important: Free arm cover 121 must be kept closed. The Pfaff 1069 has a special bobbin limportant when re-ordering(. U 30