Philips DVP3570 User manual - Page 22

LIST OF SETTINGS Category Menus Audio Dual mono Down Sampling Options/SubMenus Stereo L-ch R-ch On Off DRC Effect On 7/8 6/8 5/8 4/8 3/8 2/8 1/8 Off Normal Living Room Hall Arena Cave Concert Hall Bath Room Cathedral Digital Out • Refer to page 10 for more information. Bitstream LPCM Other Auto Power Off On Off HDMI HDMI Auto Video 480p 720p 1080i 1080p HDMI Bitstream Audio LPCM Off EasyLink On (HDMI CEC) Off Ratings Rating Lock Level Factory Default New PIN Yes No Off 8 [Adult] 7 [NC-17] 6 [R] 5 [PGR] 4 [PG13] 3 [PG] 2 [G] 1 [Kid Safe] Product Info 22 EN Description This unit allows you to select a sound mode. • When playing back disc with copyright protection, the sound will be down sampled at 48kHz, even if you set to "Off". Set to "On" when outputting in 48kHz. Set to "Off" when outputting the original sound. This function is available only on the discs which are recorded in the Dolby Digital format. "On" "7/8 - 1/8" "Off": Compress the range between soft and loud sounds. You can set the reverberation effect. Normal: no effects (original sound) Living Room: sounds as if you are in a living room Hall: sounds as if you are in a hall Arena: sounds as if you are in an arena Cave: sounds as if you are in a cave Concert Hall: sounds as if you are in a concert hall Bath Room: sounds as if you are in a bath room Cathedral: sounds as if you are in a cathedral • Set to "Bitstream" when the unit is connected to a Dolby Digital decoder. • When HDMI cable is connected, make sure "HDMI Audio" setting is set to "Off" to change the "Digital Out" setting. "Bitstream": Outputs a Dolby Digital signals. "LPCM": Convert the Dolby Digital into LPCM (2 channel). Set to "On" to turn this unit off automatically after 30 minutes of no use. You cannot select the video resolutions which are not supported by the connected TV, except when this unit's HDMI OUT jack is connected to a DVI compatible display devices with an HDMI-DVI cable (default is 480p in such case). • Video and audio signals may be distorted temporarily when switching to / from the HDMI output mode. HDMI Video: • Auto: HDMI video resolution will be selected automatically depending on the connected HDMI device. If you want to change the resolution manually, press [HDMI] repeatedly. • When you make a selection, the TV monitor temporarily goes blank and then comes back again. If it does not, press [HDMI] to change the resolution or press and hold [B (play)] on the front panel for 5 seconds to change the setting back to its default. EasyLink (HDMI CEC): • This feature is available only when the display device is connected with an HDMI cable, and when it supports EasyLink (HDMI CEC) feature. • Refer to page 23 for more information. Sets the rating level for the disc playback. Sets the new password for the "Ratings Lock" setting. "Yes": Resets all the settings, except for "Ratings Lock", in "Settings" to the factory default. "No": Does not perform the initialization. "Product Info" screen provides you with the information on this unit's hardware and software version information.