Pioneer AVH-P6300BT Owner's Manual - Page 64
Auto EQ auto-equalizing - microphone for
UPC - 884938122740
View all Pioneer AVH-P6300BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Section 14 Menu operations ! You can operate this function only for the video signal input into the AV input. 1 Display the system menu. Refer to Introduction of menu operations on page 52. 2 Touch Video Signal Setting on the function menu. Video Signal Setting items are displayed. ! AV - Adjusts the AV video signal ! AUX - Adjusts the AUX video signal ! Camera - Adjusts the rear view camera video signal 3 Touch c or d to select the desired video signal appears. Auto-PAL-NTSC-PAL-M-PAL-N- SECAM Auto EQ (auto-equalizing) The auto-equalizer automatically measures the car's interior acoustic characteristics, and then creates an auto-equalizer curve based on that information. WARNING As a loud tone (noise) may be emitted from the speakers when measuring the car's interior acoustic characteristics, never perform auto EQ while driving. CAUTION ! Thoroughly check the conditions before per- forming auto EQ as the speakers may be damaged if these functions are performed when: - The speakers are incorrectly connected. (For example, when a rear speaker is connected as a subwoofer output.) - A speaker is connected to a power amp delivering output higher than the speaker's maximum input power capability. ! If the microphone is placed in an unsuitable position the measurement tone may become loud and measurement may take a long time, resulting in battery drainage. Be sure to place the microphone in the specified location. Before operating the auto EQ function ! Carry out auto EQ in as quiet a place as possible, with the car engine and air conditioning switched off. Also cut power to car phones or portable telephones in the car, or remove them from the car before carrying out auto EQ. Sounds other than the measurement tone (surrounding sounds, engine sound, telephones ringing etc.) may prevent correct measurement of the car interior acoustic characteristics. ! Be sure to carry out auto EQ using the optional microphone. Using another microphone may prevent measurement, or result in incorrect measurement of the car interior acoustic characteristics. ! In order to perform auto EQ, the front speaker must be connected. ! When this unit is connected to a power amp with input level control, auto EQ may not be possible if the power amp's input level is set below the standard level. ! When this unit is connected to a power amp with an LPF, turn this LPF off before performing auto EQ. Also set the cut-off frequency for the built-in LPF of an active subwoofer to the highest frequency. ! The distance has been calculated by computer to be the optimum delay to give accurate results for the circumstances, so please continue to use this value. - The reflected sound within the car is strong and delays occur. - The LPF on active subwoofers or external amps delay the lower sounds. ! Auto EQ changes the audio settings as follows: - The fader/balance settings return to the center position. (Refer to Using fader/ balance adjustment on page 53.) - The equalizer curve switches to Flat. (Refer to Recalling equalizer curves on page 53.) 64 En