Pioneer AVH-P6300BT Owner's Manual - Page 9
Visit our website, Resetting the microprocessor, Before you start - install manual
UPC - 884938122740
View all Pioneer AVH-P6300BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Before you start Section 02 Before you start For warranty information please see the Limited Warranty sheet included with this unit. Visit our website Visit us at the following site: http://www.pioneerelectronics.com 1 Register your product. We will keep the details of your purchase on file to help you refer to this information in the event of an insurance claim such as loss or theft. 2 Receive updates on the latest products and technologies. 3 Download owner's manuals, order product catalogues, research new products, and much more. 4 Your feedback is important in our continual effort to design and build the most advanced, consumer-focused product in the industry. Serial number Removing the front panel % Pinch the top and bottom of its right side and pull the front panel out. Take care not pinch it too tightly or to drop it, and also avoid contact with water or other fluids to prevent permanent damage. Re-attaching the front panel 1 Slide the front panel to the left. The front panel and the head unit are connected on the left side. Make sure that the front panel has been properly connected to the head unit. Protecting your unit from theft The front panel can be detached to deter theft. ! If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone will sound. ! You can turn off the warning tone. Refer to Switching the warning tone on page 63. 2 Press the right side of the front panel until it is firmly seated. # If you can't attach the front panel to the head unit successfully, try again. Forcing the front panel into place may result in damage. Important ! Handle gently when removing or attaching the front panel. ! Avoid subjecting the front panel to excessive shock. ! Keep the front panel out of direct sunlight and high temperatures. ! If removed, replace the front panel on the unit before starting up your vehicle. ! To avoid damaging the device or vehicle interior, remove any cables and devices attached to the front panel before detaching it. Resetting the microprocessor By pressing RESET, you can reset the microprocessor to its initial settings without changing the bookmark information. The microprocessor must be reset in the following situations: ! Before using this unit for the first time after installation ! If the unit fails to operate properly ! When strange or incorrect messages ap- pear on the display En 9