Pioneer AVIC-88DVD Owner's Manual - Page 66

Message Route calculation was not possible because the destination is too far. Route calculation was not possible because the destination is too near. Route calculation was not possible due to traffic regulations. Route calculation was not possible because no guidance can be provided around the destination or the starting point. There is no route to the destination. The maximum number of registrations has been completed. Please clear existing registered items and re-register current item. Memory is full. Irregular character strings. Please input again. An error has occurred. Please note the following error code and switch power off. DVD Player is overheating. Discontinue until temperature drops. DISC DATA READING When The destination is too far. The destination or way point(s) is too close. •The destination or way point(s) are in a Control Traffic Zone (CTR) and the route calculation is hampered. •Your vehicle is currently in a Control Traffic Zone (CTR) and the route calculation is hampered. The destination, way point(s), or starting point are in an area where no road exists (e.g. a mountain) and the route calculation is impossible. The destination or way point(s) are in an isolated island, etc. without a ferry and the route calculation is impossible. If there are already 300 items when you attempt to register an item in the Address Book. What to do • Set a destination closer to the starting point. • Set one or more way points. Set a destination [and way point(s)] farther from the starting point. •Set a destination and way point(s) outside the CTR if you know where the restricted area is. •Try the destination or way point(s) away from the currently set points to some extent. •Drive your vehicle to an unrestricted area and reset the destination and way point(s). •Set a destination and way point(s) on roads. •Reset the destination after you drive the vehicle to any road. Change the destination. Delete some destinations as appropriate. When the total 300 resistered points are in the PC card and Address Book, you attempt moving an item to the Address Book from PC card. A symbol that cannot be pronounced was entered. In the case of a system failure. The built-in DVD drive has overheated. With the map disc inside the Navigation unit, the NAVI source screen has been displayed by pressing the NAVI/AV button. Delete unnecessary data and try to register again. Enter a word that can be pronounced. Note down the error code shown on the screen; turn off the power, and then contact your nearest Pioneer service facility. Cut the power off, and wait for a while before turning the power on again. Select any other source besides "NAVI SOURCE", or press the NAVI/ AV button to switch to the Navigation map. If a message about the PC card is displayed • If there is no more space on the PC card or 300 items of data are already stored in one group, either delete unnecessary data or create a new group. • If the data read from the PC card combined with the data registered in the Address Book exceeds 300 items, either delete unnecessary data or reduce the amount of data read from the PC card. Appendix 64