Pioneer FH-X700BT Owner's Manual - Page 18

Section 03 Installation Additional information 1 2 Install the microphone clip on the steer- ing column. 1 2 2 1 Microphone clip 2 Clamp Use separately sold clamps to secure the lead where necessary inside the vehicle. When installing the microphone on the steering column 1 Install the microphone on the microphone clip. 1 2 3 4 1 Microphone 2 Microphone base 3 Microphone clip 4 Fit the microphone lead into the groove. # Microphone can be installed without using microphone clip. In this case, detach the microphone base from the microphone clip. To detach the microphone base from the microphone clip, slide the microphone base. 3 1 Double-sided tape 2 Install the microphone clip on the rear side of the steering column. 3 Clamp Use separately sold clamps to secure the lead where necessary inside the vehicle. Adjusting the microphone angle The microphone angle can be adjusted. Troubleshooting Symptom Cause Action The display automatically returns to the ordinary display. You did not perform any operation within about 30 seconds. Perform operation again. The repeat play range changes unexpectedly. Depending on Select the repeat the repeat play play range again. range, the selected range may change when another folder or track is being selected or during fast forwarding/reversing. A subfolder is not played back. Subfolders cannot be played when FLD (folder repeat) is selected. Select another repeat play range. NO XXXX appears when a display is changed (NO TITLE, for example). There is no embedded text information. Switch the display or play another track/file. The unit is malfunctioning. There is interference. You are using a device, such as a cellular phone, that transmits electric waves near the unit. Move electrical devices that may be causing the interference away from the unit. Symptom Cause Action The sound from the Bluetooth audio source is not played back. There is a call in The sound will be progress on a played back when Bluetooth con- the call is terminected cellular nated. phone. A Bluetooth connected cellular phone is currently being operated. Do not operate the cellular phone at this time. A call was Reconnect the made with a Bluetooth con- Bluetooth con- nection between nected cellular this unit and the phone and then cellular phone. immediately ter- minated. As a result, commu- nication be- tween this unit and the cellular phone was not terminated properly. Error messages When you contact your dealer or your nearest Pioneer Service Center, be sure to note the error message. 18 En