Pioneer PDP-R04U Owner's Manual - Page 78
Media Receiver rear view, VCR or DVD recorder, HOME MENU, ENTER
UPC - 073168074213
View all Pioneer PDP-R04U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
11 Enjoying through External Equipment Connecting a VCR controller Connect the supplied VCR controller to the Media Receiver. This allows you to preset digital TV programs for recording, using the Electronic Program Guide. When the specified time comes, the system in the standby mode is automatically switched on and the specified TV program is recorded using the connected VCR or DVD recorder. Media Receiver (rear view) SERVICE ONLY IN OUT CONTROL VCR CONTROL IN OUT IN OUT S-VIDEO DIGITAL OUT OPTICAL INPUT 2 VIDEO R-AUDIO-L VIDEO (TS) S400 DTV-ANTENNA IN INPUT 1 R-AUDIO-L COMPONENT VIDEO Y CB/PB CR/PR A ANTENNA/CABLE B MONITOR OUT S-VIDEO VIDEO R-AUDIO-L S-VIDEO R-AUDIO-L INPUT 3 Y CB/PB CR/PR AC INLET BLACK WHITE SYSTEM CABLE • Make sure to leave the VCR power on when presetting TV programs for recording with the VCR controller. • Be sure to firmly connect the VCR controller to the VCR control terminal on the rear of the Media Receiver. If you have mistakenly connected it to the CONTROL IN or CONTROL OUT terminal, remote control or other operations may be disabled. VCR CONTROL Position the light emitting section on the VCR controller cable so that it faces the VCR. (Once you have positioned the VCR controller, secure with the tape provided.) VCR or DVD recorder Remote control sensor Use the following procedure to set the manufacture of the recording equipment: 1 Press HOME MENU. 2 Press / to select "DTV Setup", and then press ENTER. 3 Press / to select "VCR Control", and then press ENTER. 4 Press / to select the manufacture of the recording equipment, and then press ENTER. 5 Check that the power to the recording equipment is on, and insert tape into the slot. • Insert tape you think it all right to erase its contents. The contents will be erased because Rec and Stop codes are output in the test. • Check that the light emitting section on the VCR controller cable faces the recording equipment. 6 Press ENTER to execute recording test. • If the recording equipment fails to start and stop recording, check and change the specified recording equipment manufacture. 7 Press / to select "YES", and then press ENTER. 8 Press HOME MENU to exit the menu. • The screen for recording test appears. 78 En PDP5040HD-Eng (65-80) 78 • Even if you correctly specify the manufacture of the recording equipment, control of some models may be disabled. • Perform the recording test when the recording equipment is not in recording standby or is not recording. • The recording test takes approximately 10 seconds. • The PIONEER 1 (DVD recorder) has been set as the factory default. 7/24/03, 2:00 PM