Pioneer PRO-1540HD Owner's Manual - Page 25
Connecting the power cord, Routing cables
View all Pioneer PRO-1540HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Preparation 05 English Connecting the power cord Connect the power cord last, after all other components are connected. Plasma Display (rear view) AC IN terminal is located on the upper edge of the compartment. Power cord Noise filter Partially eliminates noise caused by the power source. CAUTION • Use only the supplied power cord. • Use only the specified power supply voltage; neglecting this can result in fire or electric shock. • For the Plasma Display System, a three-core power cord with a ground terminal is used for safety reasons. Always connect the power cord to a three-pronged outlet and make sure that the cord is properly grounded. Routing cables When the speakers are installed on the sides Rear view NOTE • Always turn the panel's power OFF when connecting or disconnecting power cords. • Disconnect the power cord from the wall outlet when the Plasma Display Panel is not going to be used for a long period of time. Speaker cable Speed clamp Attaching speed clamps to the main unit Attach the speed clamps using any of the 4 holes you prefer (50 inches, 3 holes: 42 inches, 2 holes) marked with an arrow ( ) below, depending on your routing system. for PRO-1540HD for PRO-1140HD for PRO-940HD Speed clamp Speaker cable Attaching and removing speed clamps Insert [1] into an appropriate hole on the rear of the Plasma Display then snap [2] into the back of [1] to lock the clamp. Speed clamps are designed to be difficult to release once in place. Please attach them carefully. Use pliers to twist the clamp 90º, pulling outward. The clamp may deteriorate over time and become damaged if removed. 2 1 NOTE • Use the supplied speed clamps as necessary. • Bundle speaker cables so that none are pinched. 25 En