Pioneer PRS D1000M Owner's Manual - Page 11
English, EspaÑol, Deutsch, FranÇais, Italiano, Nederlands
UPC - 012562821375
View all Pioneer PRS D1000M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS Two Amplifier (Ex. Bridge) MODE SELECT switch must be in MASTER position. Connect to a car stereo. For details, see the SYNC OUTPUT "Connection Diagram". 2 Ω to 16 Ω MODE SELECT switch must be in SYNC INV position. Connecting speaker wire (sold separately). Connecting wire with RCA pin plugs (sold separately). SYNC INPUT • Only use speakers having an impedance of 2 Ω to 16 Ω. In addition, in the case of connecting multiple speakers with a bridge, check that the synthetic impedance is at least 2 Ω. • The setting of the POWER MODE switch varies according to the speaker impedance. Slide the POWER MODE switch to the HI-CURRENT position if the impedance is from 2 Ω to less than 4 Ω, or slide it to the NORMAL position if the impedance is from 4 Ω to 16 Ω. The same setting is used for both amplifiers. • When switching to the SYNC INV mode, the seal over the MODE SELECT switch must be peeled off and you can find SYNC INV switch. Peel off the seal after checking that connections are correct. Two Amplifier MODE SELECT switch must be in MASTER position. SYNC OUTPUT Connect to a car stereo. For details, see the "Connection Diagram". 1 Ω to 8 Ω MODE SELECT switch must be in SYNC position. Connecting wire with RCA pin plugs (sold separately). 1 Ω to 8 Ω SYNC INPUT • Use speakers having an impedance from 1 Ω to 8 Ω. • The setting of the POWER MODE switch varies according to the speaker impedance. See the "Setting the Unit" section for details. The same setting is used for both amplifiers. 10