Pioneer PRS D1000M Owner's Manual - Page 9

ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS Connecting the Speaker Output Terminals 1. Expose the end of the speaker wires using nippers or a cutter by about 10 mm (3/8 inch) and twist. Twist Using the Speaker Input Connect the car stereo speaker output wires to the amplifier using the supplied speaker input wire with RCA pin cord. • Slide the input switch to the right. 7 Connections when using the speaker input 10 mm (3/8 inch) 2. Attach lugs to speaker wire ends. Lugs not supplied. • Use pliers, etc., to crimp lugs to wires. Lug Car Stereo Speaker output Speaker wire 3. Connect the speaker wires to the speaker output terminals. • Fix the speaker wires securely with the terminal screws. Terminal screw Speaker output terminal Speaker wire White: Black: Black: Red: Left + Left ≠ Right ≠ Right + To RCA input jack of this unit. Speaker input wire with RCA pin cord • As a result of connecting the car stereo speaker output wire to the amplifier, the power of the amplifier is turned on automatically when the car stereo is turned on. It is not necessary to connect the system remote control wire in this case. • In the case the amplifier and head unit are connected using a speaker input wire with RCA pin cord, the amplifier power is only turned on when one amplifier is being used. If two or more amplifiers are synchronously connected in combination, connect the head unit and all of the amplifiers with the system remote control wire. Note: • Connect the system remote control wire when the power of the amplifier is not to be turned on when the car stereo is turned on. 8