Pioneer PRS D1000M Owner's Manual - Page 7

ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS Connection Diagram • This diagram shows connections using external output. Slide the input switch to the left. • In the case of connecting the external output from a car stereo to an RCA input, use the jack used for full- range output. This is because the LPF of the amplifier cannot be turned OFF. If this jack cannot be used, connect the subwoofer output jack to the RCA input. • When you connect with speaker output, connections defers from the diagram. For details, see the "Using the Speaker Input" section. In either case, you need to set the input switch. For details, see the "Setting the Unit" section. • Always use the special red battery and ground wire ([RD-223] and [RD-222]), which are sold separately. Connect the battery wire directly to the car battery positive terminal (+) and the ground wire to the car body. There is the risk of a fuse burning out if only one of these is connected. Grommet Special red battery wire After making all other connections at the amplifier, connect the battery wire terminal of the amplifier to the positive (+) terminal of the battery. Fuse (30 A) × 3 [RD-223] (sold separately) Ground wire (black) Connect to metal body or chassis. External Output [RD-222] (sold separately) Bass Boost Remote Control Bass Boost Remote Control Wire Car stereo with RCA output jacks 6 m (19 feet 8 inch) Jack for the bass boost remote control Connect this jack and the bass boost remote control with the bass boost remote control wire. Connecting wire with RCA pin plugs (sold separately). RCA input jack Fuse (40 A) Speaker output terminal See the "Connecting the Speaker Wires" section for speaker connection instructions. SYNC OUTPUT/SYNC INPUT jack See the "Connecting the Speaker Wires" section for SYNC OUTPUT/SYNC INPUT jack connection instructions. System remote control wire (sold separately) Connect the male terminal of this wire to the system remote control terminal of the car stereo (SYSTEM REMOTE CONTROL). The female terminal can be connected to the auto-antenna relay control terminal. If the car stereo does not have a system remote control 6 terminal, connect the male terminal to the power terminal through the ignition switch.