Pioneer PRS D1000M Owner's Manual - Page 8

Connecting the Unit Connecting the Power Terminal • Always use the special red battery and ground wire ([RD-223] and [RD-222]), which are sold separately. Connect the battery wire directly to the car battery positive terminal (+) and the ground wire to the car body. There is the risk of a fuse burning out if only one of these is connected. 1. Pass the battery wire from the engine compartment to the interior of the vehicle. • After making all other connections to the amplifier, connect the battery wire terminal of the amplifier to the positive (+) terminal of the battery. [RD-223] Engine Fuse (30 A) compart- ment Interior of the vehicle 2. Twist the battery wire, ground wire and system remote control wire. Twist 3. Attach lugs to wire ends. Lugs not supplied. • Use pliers, etc., to crimp lugs to wires. Lug Lug Battery wire Ground wire Fuse (30 A) Drill a 14 mm Positive terminal (1/2 inch) hole Insert the O-ring rubber into the vehicle grommet into the vehicle body. body. [RD-222] Engine Fuse (30 A) compartment Interior of the vehicle Positive terminal Insert the O-ring rubber grommet into the vehicle body. Drill an 8 mm (3/8 inch) hole into the vehicle body. 4. Connect the wires to the terminal. • Fix the wires securely with the terminal screws. GND terminal Power terminal System remote control terminal System remote control wire Ground wire Battery wire WARNING Failure to securely fasten the battery wire to the terminal using the terminal screws could cause the terminal area to overheat and could result in damage and injury including minor burns. 7