Pioneer PRS D1000M Owner's Manual - Page 15
Example of installation on the floor, mat or on the chassis, Replacing the terminal cover
UPC - 012562821375
View all Pioneer PRS D1000M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS Example of installation on the floor mat or on the chassis 1. Place the amplifier where it is to be installed. Insert the supplied tapping screws (4 × 18 mm) into the screw holes. Push on the screws with a screwdriver so they make marks where the installation holes are to be located. 2. Drill 2.5 mm (1/8 inch) diameter holes at the point marked, and install the amplifier, either on the carpet or directly to the chassis. Replacing the terminal cover 1. Align the unit and terminal cover, and insert the screw. 2. Tighten the screw with a 4 mm hexagonal wrench. Screw Tapping-screws (4 × 18 mm) Terminal Cover Drill a 2.5 mm (1/8 inch) diameter hole Floor mat or chassis 14
14
ENGLISH
ESPAÑOL
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
êìëëäàâ
Example of installation on the floor
mat or on the chassis
1.
Place the amplifier where it is to be
installed. Insert the supplied tap-
ping screws (4
×
18 mm) into the
screw holes. Push on the screws with
a screwdriver so they make marks
where the installation holes are to
be located.
2.
Drill 2.5 mm (1/8 inch) diameter
holes at the point marked, and
install the amplifier, either on the
carpet or directly to the chassis.
Replacing the terminal cover
1.
Align the unit and terminal cover,
and insert the screw.
2.
Tighten the screw with a 4 mm
hexagonal wrench.
Drill a 2.5 mm (1/8 inch)
diameter hole
Tapping-screws
(4
×
18 mm)
Floor mat
or chassis
Screw
Terminal Cover