Pioneer SC-LX85 Operating Instructions - Page 104

14 Additional information In the receiver's IP settings, set DHCP to ON. After the setting is completed, turn the receiver's power off. Next, turn the receiver's power back on and check whether the wireless LAN converter's settings can be displayed with the receiver. If the settings can be displayed, change the IP address settings of the receiver and wireless LAN converter as necessary. The IP address settings of the receiver and wireless LAN converter do not match the settings of the wireless LAN router, etc. ! Check the IP address settings of the receiver and wireless LAN converter (including the DHCP setting). If the receiver's DHCP setting is "ON", turn the receiver's power off, then turn the power back on. Check that the IP addresses of the receiver and wireless LAN converter match the settings of the wireless LAN router, etc. If the receiver's DHCP setting is "OFF", set an IP address matching the network of the base unit (wireless LAN router, etc.). For example, if the wireless LAN router's IP address is "192.168.1.1", set the receiver's IP address to "192.168.1.XXX" (*1), the subnet mask to "255.255.255.0", the gateway and DNS to "192.168.1.1". Next, set the wireless LAN converter's IP address to "192.168.1.249" (*2). (*1) Set the "XXX" in "192.168.1.XXX" to a number between 2 and 248 that is not assigned to other devices. (*2) Set the "249" in "192.168.1.249" to a number between 2 and 249 that is not assigned to other devices. 104 En Try making the wireless LAN converter's advanced settings. ! The wireless LAN converter can be connected to a computer to make the advanced wireless LAN settings. For details, see the CD-ROM included for the wireless LAN converter. Check the settings of the wireless LAN router, etc., then change the settings of the wireless LAN converter. Note, however, that making the advanced wireless LAN settings will not necessarily improve the wireless LAN environment. Be careful when changing the settings. The access point is set to conceal the SSID. ! In this case, the SSID may not be dis- played on the access point list screen. If not, set the SSID, etc., by making the wireless LAN converter settings on the receiver manually. The access point's security settings use WEP 152-bit length code key or shared key authentication. ! The receiver does not support WEP 152-bit length code key or shared key authentication. Network connections cannot be established even when the above measures are taken. ! Reset the wireless LAN converter. After this, redo the wireless LAN converter's settings. About resetting 1. Check that the wireless LAN converter's power is on. 2. Press the wireless LAN converter's reset button for at least 3 seconds. 3. Release the reset button. When the wireless LAN converter is restarted, the resetting procedure is completed. About status messages Refer to the following information when you come up with a status message while operating the Home Media Gallery. Status messages STARTING H.M.G. Connection Down File Format Error Track Not Found Server Error Server Disconnected empty Preset Not Stored Out of Range License Error Item Already Exists Favorite List Full Descriptions A component on the network, including a PC, is currently being connected. Wait for a while. The selected category or Internet radio station cannot be accessed. Cannot be played back for some reasons. The selected song has not been found anywhere on the network. The selected server cannot be accessed. The server has been disconnected. There are no files stored in the selected folder. The selected Internet radio station is not currently registered and saved. The value entered is beyond the permitted range of the network settings. The license for the contents to be played back is invalid. This is displayed when the file you have attempted to register in the Favorites folder has already been registered. This is displayed when you have attempted to register a file in the Favorites folder but the Favorites folder is already full.